How to remove an air suspension air compressor?

Part 1 of 2: Removing the air suspension air compressor from the vehicle. Step 1: Turn the ignition switch to the ON position. Step 2: Release the air pressure. Using the scan tool, open the vent valve and relieve all of the air pressure from the air lines. After the air lines have been depressurized, close the vent valve.

How long does it take to replace a Mercedes air compressor?

Replacing the Mercedes suspension air compressor is an easy procedure that can be performed by the vehicle owner in about one hour. It is important to test a Mercedes-Benz air suspension compressor before replacing it.

How to test Mercedes Benz air suspension compressor?

It is important to test a Mercedes-Benz air suspension compressor before replacing it. In some cases, the air compressor may run and appear to work properly but it does not generate enough pressure to raise the vehicle. You can use a multi-system diagnostic scanner such as Autel MaxiCOM to activate the air suspension compressor for 40 seconds.

How to replace an air suspension compressor in a Lincoln Town Car?

This video shows automotive repair professionals how to remove a faulty air suspension compressor from a 1990-2011 Lincoln Town Car, Ford Crown Victory, or Mercury Grand Marquis and replace it with a new Arnott Air Suspension Compressor and Dryer Assembly P-2935 (98-02) P-2936 (90-97 & 03-11) .

When to remove an air suspension air compressor?

You will be able to tell if your air suspension air compressor is failing if the vehicle starts to ride lower than usual or the vehicle ride height never changes when the vehicle load changes. Part 1 of 2: Removing the air suspension air compressor from the vehicle.

How do you remove an air compressor from a car?

Step 6: Remove the compressor. Air compressors are held to the vehicle by three or four bolts. Using the necessary size socket and ratchet, remove the bracket bolts that secure the air compressor to the vehicle, then remove the air compressor and bracket assembly from the vehicle.

What to do if there is no power to the air suspension pump?

If there is no power going to the air suspension compressor, check the air suspension fuse and relay. Here is a picture that shows no power to the air suspension pump. The next step would be to use a professional diagnostic scanner such as the iCarsoft MB II to check the fault codes for the Air Suspension Control Unit.

When to replace Mercedes-Benz air suspension compressor?

5350 A9/1y1 (AIRmatic pressure release valve): Open Circuit. It is highly recommended to replace the Mercedes air compressor relay when you replace the air compressor. Before you proceed with the air suspension compressor’s replacement, inspect the wires that go to the air compressor for damage.

Where is the air suspension compressor on a Honda Accord?

Check voltage at the air compressor Locate the air suspension compressor. It is behind the front bumper. Check if power is going to the air suspension compressor. You can unplug the electrical connector that goes to the air suspension compressor, as shown in the picture below.

How much does it cost to replace rear air suspension?

You don’t have to. Rather than continue to fuss with that air suspension, you can just ditch it entirely and replace it. This kit from Strutmasters will allow you to replace your rear air suspension for under $400. That’s less than half of what it would cost you to replace it with air suspension components from the factory.

What should I do if my air suspension is not working?

Procedures vary depending on the application, but may require removing a fuse, cutting a wire or splicing a resistor into a strut wiring harness to trick the module into thinking a solenoid or height sensor is still there when it is not. Make sure to review the conversion kit’s instructions or check other sources like manufacturer TSBs.

How does a new air suspension compressor work?

This new compressor includes a release solenoid and an integrated dryer and filter. The compressor comes pre-wired with new air hoses and fittings for plug and play operation. This AMK compressor comes with vibration isolators, mounting hardware and a new compressor relay.

How does an AMK air suspension compressor work?

This AMK air supply unit includes a bracket so it can easily replace the OE pump and bracket and will fit within the compressor box. This new compressor includes a release solenoid and an integrated dryer and filter. The compressor comes pre-wired with new air hoses and fittings for plug and play operation.

How can you tell if your air suspension system is failing?

Without the air compressor, the entire suspension system would not be able to function. You will be able to tell if your air suspension air compressor is failing if the vehicle starts to ride lower than usual or the vehicle ride height never changes when the vehicle load changes.

How to install air suspension in Mercedes medic?

Using a 10 mm wrench, turn the bolt counterclockwise. Once the bolt is loose, pull out the air line. There is a small rubber gasket on the metal connector at the end of the threads, make sure not to damage it. Unplug two electrical connectors that go to the air compressor.

How do you install a new AC compressor?

Install the new compressor in reverse order. The warranty may also require you to change the orifice tube and receiver/dryer. Install and tighten the compressor-mounting bolts and hook up the electrical connectors. Replace the refrigerant tubes’ O-rings and lubricate with the proper oil.

Why is my air suspension not working properly?

Diagnosis: The Electronic Controlled Air Suspension (ECAS) compressor was running, but the back end would not return to normal ride height. Root Cause: Compressor check valve sticking in the compressor housing, not allowing the compressor to build pressure and raise the rear.

What to look for in repairing vs replacing air suspensions?

Remanu-factured and new aftermarket electronic air struts and compressors can provide a more cost-effective alternative for those who want to retain the full functionality of their air ride suspension.

Do you have to replace springs on air compressor?

Damaged springs must be replaced as an individual assembly (replacement in pairs is not necessary with air springs). If unfolded, the spring must be carefully inspected for cuts or cracks before it is reinflated. It is very important to ensure that the source of air for the compressor is clean and as dry as possible.

Navigation