How to remove a window from a Volkswagen Golf?
Press spreader pin -3- flush into spreader plug -4-. Insert door window -9- into door -1–arrows- and insert door window into slot of window regulator guide. Make window -1- engage in window regulator -2- by pressing slightly from above. Then perform remaining installation in reverse order of removal.
How do you repair a VW Golf door?
Screw 5 mm bolt (approx. 70 mm long) into spreader pin -3-, and pull bolt together with spreader pin out of spreader plug -4-. Screw an 8 mm bolt (approx. 80 mm long) into spreader plug -4-. When screwing bolt into spreader plug, do not apply excessive pressure on plug. It otherwise falls inwards into door.
What should the side of a Volkswagen car door look like?
The side facing into the car will now pop off (picture 1), and reveal a couple Philips head screws. A magnetic screwdriver is VERY helpful for this, as the screws are set deep into the door, especially during re-assembly. Once the screws are out remove the inner handle and it should look like picture two.
How do you take a car door off a VW?
After all the screws are out, the door will not just fall off. It is held in place by a punch of clips. You need to pull out on the bottom of the panel until the bottom is no longer connected, then push up to allow the door to pop off the upper clips and up off of the lock and out of the window slot.
What kind of window regulator do I need for a VW Passat?
This guide applies to VW Jetta (1999-2005), VW New Beetle (1998-2010), VW Golf (1999-2006), VW GTI (1999-2005), and VW Passat (1998-2005) models. Pull Tip: Before you can remove the window regulator, you first need to remove the door trim panel and the door glass.
How do you remove glass from front door?
Loosen the two T30 (or 10mm bolts) screws, do not remove them; otherwise, the back part of the clamp will fall into the door Remove the glass by pulling the back part of the glass up and forward and as it comes up it will come past the frame of the door.