How to remove a rack from a jeep?
Remove the 13mm bolt holding the steering shaft to the rack. You will need to completely remove the bolt before you can pull the shaft off the rack. 8. From here you can go ahead and remove the pressure line first from the rack (which is the top line) and then remove the bottom return line from the rack.
How to install rack and pinion in Jeep?
Worm the rack up into the unibody on the passenger side and now you should have clearance of the front diff. 3. Move the “rack” all the way to the passenger side, flip the rack assembly itself and then you can now move the assembly into place and bolt it in.
Why is my steering tight after a rack install?
When a new rack or old unit. The issue here is usually not the new part. However, the new part has most likely revealed that the pump is not creating enough pressure. This tight
Can a steering rack be moved to the passenger side?
The tricky part is you now have to move the steering “rack” all the way to the passenger side. You can do this by pushing the drivers side tie rod into the rack itself (be careful as there’s plenty of fluid left in the rack and will squirt).
When a new rack or old unit. The issue here is usually not the new part. However, the new part has most likely revealed that the pump is not creating enough pressure. This tight
Remove the 13mm bolt holding the steering shaft to the rack. You will need to completely remove the bolt before you can pull the shaft off the rack. 8. From here you can go ahead and remove the pressure line first from the rack (which is the top line) and then remove the bottom return line from the rack.
The tricky part is you now have to move the steering “rack” all the way to the passenger side. You can do this by pushing the drivers side tie rod into the rack itself (be careful as there’s plenty of fluid left in the rack and will squirt).
Worm the rack up into the unibody on the passenger side and now you should have clearance of the front diff. 3. Move the “rack” all the way to the passenger side, flip the rack assembly itself and then you can now move the assembly into place and bolt it in.