How to remove a distributor?
The distributor is held in place by a bolt typically called the hold down bolt. Remove the bolt and the clamp that is under the bolt. When you have removed the bolt and clamp, you can lift the distributor body out of the engine block. Note: On older vehicles it may take some force to remove the distributor.
How to retime a distributor?
To adjust your timing, all you need to do is turn the distributor housing one direction or the other, depending on whether or not you want to advance or move back the timing. If the rotor turns clockwise, you’ll advance the timing by rotating the distributor counterclockwise, and vice versa.
Where is the manual button on a GMC Sierra?
To adjust the front seatback, lift the manual lever located on the outboard side of the seat. Release the lever to lock the seatback where you want it. Lift the lever again without pushing on the seatback and the seatback will go to an upright position.
How much does a GMC Sierra 2500HD cost?
Includes $450 in cash and discounts. Includes $450 in cash and discounts. Includes $950 in cash and discounts. Includes $950 in cash and discounts. Includes $950 in cash and discounts. Includes $1,450 in cash and discounts.
How do you heat the front seat on a GMC Sierra?
To heat only the seatback, press the vertical button with the heated seatback symbol. An indicator light on the button will glow to designate that only the seatback is being heated. The engine must be running for them to operate. The heated front seats will be canceled after the ignition is turned off.
Where is the power lumbar on a GMC Sierra?
Your vehicle’s seats may be equipped with power lumbar. You can increase or decrease lumbar support in an area of the lower seatback with this control, located on the outboard sides of the front seat(s). To increase support, press and hold the front of the control. To decrease support, press and hold the rear of the control.