How to install engine brake on MBE 4000?
Install a new seal on the valve stem. With the fingers, press the seal onto the valve stem past the indentation that houses the collets when the valve is installed. Insert the spring guide over the end of the valve stem and push down until the spring guide bottoms out.
How to remove exhaust brake line from MBE?
Unscrew the exhaust brake compressed-air line fitting from the exhaust brake cylinder and remove the line. Remove four locknuts from the bolts that secure the exhaust brake valve housing to the turbocharger. Remove the housing, leaving the bolts in place. Discard the locknuts.
Where can I get a MBE900 Mercedes truck?
Mo Via Blackpool,Lancs. Prepare thyself for the MBE haters……Although not a single one has owned one IIRC. I ran a 4000 for 8yrs, and it was a good enough motor that was EXCELLENT on fuel. You can call the afternoon shift guys (4pm onwards) at Interstate Detroit in Altoona,Ia for any advise on it too.
Where are the constant throttle valves located in the MBE 4000?
The constant-throttle valves use the air that escapes through them on the compression stroke to provide braking force. The constant throttles are small valves which are built into the cylinder heads and positioned opposite the exhaust valves. When open, a link is created between the combustion chamber and the exhaust port.
How does the exhaust brake work on a MBE?
Engine braking is controlled by a pneumatically-operated exhaust brake on the turbocharger and by a constant-throttle system. For greater braking power, an optional turbo brake is available. Disconnect the batteries. Chock the rear tires and tilt the hood. To gain access to the exhaust brake, remove the air cleaner.
Where to Mount EPV valve on MBE 4000?
Mount the EPV valve on left side of bracket using two M8 x 50 mm bolts. Torque to 25 N·m (18 lb·ft) tightening torque. Install large hollow screw in threaded connection. Torque to 50 N·m (37 lb·ft).