How to install axle seal on Jeep Wrangler?
Drain the differential, pull the cover, mark orientation of carrier bearing caps & placement of carrier shims after pulling the carrier. If you’re doing it yourself, get an axle seal install tool or build one. Plenty of DIY videos. Digging around a bit more, I think I found my answer. There are three part numbers
How much does it cost to replace rear axle seal?
If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.
When to replace rear axle bearings and seals?
After the axle has been removed inspect the bearing and seal surface to check for wear and scoring and replace if damaged. If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely.
Is it difficult to replace an axle seal as a DIY project?
Is it difficult to replace an axle seal as a DIY project? In a typical front-wheel drive car, the hardest part is to remove the CV axle (driveshaft) to get to the seal. Without a hoist and proper tools it’s quite difficult, especially if the seal is leaking on the side of the longer driveshaft (the right side in most cars).
What should it cost to repair right axle seal leaks?
Fixing an axle seal can cost anywhere from $150 to several hundred dollars, depending on the make and model of your car. If you detect a leak it’s better to fix it sooner rather than later, as ruining your transmission is an expensive repair.
What are front axle seals?
A front axle seal is a metal and rubber device used to not only prevent axle lube from seeping out of the axle housing, but it is also designed to prevent dirt, water and contamination from gaining access into the axle housing and contaminating the gear lube. Found in the front axle of a four-wheel drive vehicle,…
How does axle seal work?
Axle seals have two primary functions in the drive trains of cars and trucks. The first purpose of an axle seal is to keep gear oil from escaping. Without this sealing function, the gear oil would leak out and contaminate various components, such as brake shoes, and the transmission or differential could overheat.