How to install an aux system in a Honda Accord?
This is an instruction set for installing an auxiliary system in a 2003-2007 Honda Accord. After gathering the required tools and items, you will remove the compartments under the stereo. Once all compartments are removed, the internal wiring will be revealed so you can attach the auxiliary underneath the stereo. Get everything ready.
How do you replace ignition switch on Honda Accord?
Route the wiring in the same manner the old switch wiring was routed, insert the switch into the steering column, and put back the ignition switch cover and screws. Use the electrical tape to corral any of the loose wiring. Put all paneling back the way it was by following the above directions in reverse.
How do you install a spoiler on a Honda Accord?
Install the new trunk spring. Use a flat head screwdriver to pry off the trunk lid’s rear trim panel. Then, remove the trunk side floor panel. Route the wire harness through the trunk lid holes. Secure the harness to the trunk hinges with zip ties. Connect the harness to the brake light plug.
Where is the auxiliary wire in a Honda Accord?
Pass the auxiliary wire behind the glove compartment and into the wiring section. Open and empty out the glove compartment. Then, push in the flexible sides of the open glove compartment so that it slides off the corner hooks holding it open. Once doing so, the glove compartment will be open all the way and touch the mats.
Can a Honda Accord be a 5 speed manual?
If you’ve maxed out your performance mods, try converting your automatic transmission into a five speed manual. This how-to will help you to swap your Honda Accord’s automatic transmission with a 5-speed manual. This article applies to the Honda Accord (1990-2002).
How do you jack up a Honda Accord?
(Related Article: How to Jack Up Your Accord – Honda-Tech.com) Use a Phillips screwdriver to remove the hose clamps from both ends of the air intake tube. Pull the intake tube up and out of the engine bay. Then, set it aside. Slide a catch pan under the drain plug of the automatic transmission oil pan.
How do you change the automatic on a Honda Accord?
Completely slide the seat back. Remove the plastic boot-cover at the rear foot of the seat. Remove 14mm bolts from the rear brackets. Slide the seat forward. Remove the plastic boot-cover at the front foot of the seat. Remove 14mm bolts from the front brackets. Pull it out, and set aside the front seat. Figure 1.
Where is the automatic transmission mount on a Honda Accord?
The automatic transmission mount is not located in the same location as where the 5-speed transmission mount will be located. Using the same mount will cause undue stress on the axle, which will eventually lead to snapped axles. Purchase a 5-speed manual transmission mount from Honda.