How to install a load resistor for LED tail lights?
This video shows which wires you need to connect your load resistor to in order to restore cruise control to your vehicle. This also corrects hyper flash that is associated with LED tail lights.
How to know if my LED light is not working?
My LED is not working 1 Install the LED on another vehicle to see if it works there 2 Check the fuse box on your vehicle to insure no fuses are popped 3 Use alligator clamps hooked up to the car battery to test the LED 4 Turn the LED 180 degrees to see if that works
Why is one side of my HID light not working?
Only one side is working on my HID kit or LED kit. If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
What are the common problems with LED strip lighting?
1. LED strip showing the wrong color 2. LED light strip won’t turn on 3. The LED light strip won’t turn off, or can’t completely shut off 4. LED light strip only red or green or blue is working 5. LED light strip remote not working 6. LED light strip connector not working
My LED is not working 1 Install the LED on another vehicle to see if it works there 2 Check the fuse box on your vehicle to insure no fuses are popped 3 Use alligator clamps hooked up to the car battery to test the LED 4 Turn the LED 180 degrees to see if that works
Can you use LED lights on turn signals?
Yes, LED bulbs will work on a vehicle even that old. A replacement flasher relay will be required for the turn signals. Unfortunately, we do not have any full vehicle kits. You would have to remove your original bulbs to see what is there and how many you will need to replace with LED bulbs.
Do you need error free LEDs for interior lights?
Although interior lights generally do not need error free LEDs, here is a list of lights that generally do; You can determine whether you need error free lights by checking with your vehicle’s manufacturer, but suffice to say that if it is of European origin and has the CANBUS system, then error free LEDs are probably required.
What to do if you get an led error message?
However, if the error message persists, shut off the vehicle, lock it and make sure that the hood, trunk and all the doors are shut for 10 to 15 seconds. At that point, start up the vehicle and check for the error message. If the error message persists, then please contact our customer service department through phone or email.