How to get fault code on Jeep Grand Cherokee?
Retrieving major fault codes on Jeep Grand Cherokee: Turn the ignition key until the digital odometer displays, repeat three times in succession and then back to “On” (On/Off, On/Off, On/Off, On). At the fourth “On” the odometer will be replaced with codes.
What does p0702 stand for in Jeep Grand Cherokee?
P0702 is generic fault, tells that transmission have an electrical fault. P0702 is stored in engine control module. For transmission control module fault codes contact your dealer to use proper diagnostics device as DRB III or Bosch KTS. You can also read/clear faults with our diagnostic software, based on ELM327 device.
What to do if your Jeep Grand Cherokee transmission is not working?
Turn the ignition key until the digital odometer displays, repeat three times in succession and then back to “On” (On/Off, On/Off, On/Off, On). At the fourth “On” the odometer will be replaced with codes. If your car has a transmission electrical problem you can see P0700 or P0702 code.
Where is the BCM located on a 2000 Jeep Laredo?
2000 grand Cherokee Laredo where is BCM located. Gauge 2000 grand Cherokee Laredo where is BCM located JA: Okay, I’ll connect you to the Mechanic to go over that information regarding your Jeep Grand Cherokee. Before I do, is there anything else you want …
How to check engine light codes on Jeep Cherokee?
Jeep Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
2000 grand Cherokee Laredo where is BCM located. Gauge 2000 grand Cherokee Laredo where is BCM located JA: Okay, I’ll connect you to the Mechanic to go over that information regarding your Jeep Grand Cherokee. Before I do, is there anything else you want …
What kind of ignition system does a Jeep Cherokee use?
The ignition system is the one tasked with creating and delivering spark to each of the 6 cylinders. Without spark, the engine will crank but no start. The ignition system of the Jeep vehicles covered by this tutorial use either a distributor type system or a COP (Coil-On-Plug) ignition coil system. Failed ignition coil.
How to troubleshoot a no start Jeep 4.0L?
More specifically, this means that troubleshooting the problem requires that you check and confirm that: All 6 cylinders are getting spark (with a spark tester). That the fuel pump is creating enough fuel pressure. And if necessary, check the engine’s health with a compression test. I’ll go into more specific details in the following headings: 1.)