How to find the trouble code on a Mazda?
Ensure ignition switched OFF. Jump test connector (green, 1 pin) to ground Image 1 [1] Connect LED test lamp between data link connector (DLC) terminals 1 and 2 Image 1 [2] Count LED flashes and compare with trouble code table 1.2 second flashes indicate the ‘tens’ of the trouble code 0.4 second flashes indicate the ‘units’ of the trouble code
How to get Mazda codes obd1-2carpros?
Step 1 – Start the engine and allow to warm up to operating temperature, then turn the engine “OFF”. Step 2 – Next, install a jumper wire from the TEN terminal to the GND terminal, located either under the dash or hood depending on model. Step 3 – After the jumper wire has been installed, turn the ignition key to the “ON” position.
How to retrieve Check Engine Light ( CEL ) codes?
7. If any codes are retrieved, refer to Malfunction Code Charts under DIAGNOSTIC CHARTS. Repair as required. 1. Erase ECU malfunction code memory by disconnecting the negative battery cable and depressing the brake pedal for at least five seconds. Reconnect battery cable. 2. Ensure engine is at normal operating temperature. Ground test connector.
What does code 0120 mean on Mazda OBD 1?
No short flashes in a group indicate ‘0’. For example: Trouble code 0120 displayed Fig. 3 . Switch ignition OFF. Rectify faults as necessary. Ensure ignition switched OFF. Disconnect battery earth lead for at least 30 seconds. Depress brake pedal for at least 20 seconds. Reconnect battery earth lead.
How do you find the trouble code on a Mazda?
Step 4 – The check engine light will start to blink, count the number, this will be the first number of the two digit trouble code. For example, if the light blinks two times and then pauses, the first number of the code is 2.
How to find the Check Engine Light code?
Mazda Check Engine Light Codes 1 Refer to our Generic OBD II code list for definitions on all other Mazda diagnostic trouble codes. 2 Manufacturer Specific Codes 3 P1000 4 P1001 5 P1100 6 P1101 7 P1102 8 P1103 9 P1110 10 P1112
Where are the OBD codes on a pre 1995 Mazda?
Step by step guide on how to retrieve and decode Mazda pre 1995 OBD system trouble codes. Step 1 – Start the engine and allow to warm up to operating temperature, then turn the engine “OFF”. Step 2 – Next, install a jumper wire from the TEN terminal to the GND terminal, located either under the dash or hood depending on model.
No short flashes in a group indicate ‘0’. For example: Trouble code 0120 displayed Fig. 3 . Switch ignition OFF. Rectify faults as necessary. Ensure ignition switched OFF. Disconnect battery earth lead for at least 30 seconds. Depress brake pedal for at least 20 seconds. Reconnect battery earth lead.