How to calibrate the blend door actuator motor?
Blend Door Actuator Motor Calibration 1 15 in the fuse box next to the battery. 2 Remove the fuse and wait 1-2 minutes for any capacitive charges in the system to dissipate. 3 Replace the fuse. 4 Turn the ignition key to the on position. You can now watch the motors move as the system goes through the calibration routine. …
Where is the fuse on a blend door actuator?
Open hood (bonnet for the RHD guys) and locate fuse #15 in the fuse box next to the battery. Remove the fuse and wait 1-2 minutes for any capacitive charges in the system to dissipate. Replace the fuse. Turn the ignition key to the on position. You can now watch the motors move as the system goes through the calibration routine.
How to do an actuator calibration test?
ACTUATOR CALIBRATION TEST 1. Ignition on, engine not running. 2. Using the scan tool, select Actuator Calibration Test. When the test is complete, read HVAC DTCs. Does the scan tool display any DTCs? – Perform the appropriate diagnostic procedure based on vehicle HVAC system.
Do you need to calibrate a blend door?
Your blend doors should be calibrated, especially after having work done on them. I find it hard to believe that a place that does the work on blend doors doesn’t have a scanner capable of calibrating them.
What does a blend door actuator do?
Blend door actuators, also called HVAC actuators, control the position of the vents that control the flow of air into your vehicle’s passenger area. The actuators are small electric motors that move the vent doors, mixing hot air with cold air to achieve the temperature that you desire.
How do I remove blend door actuator?
Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator. These clips can be brittle and break so be gentle. Once released gently pull down on the wiring connector and remove it from the blend door actuator.
Is this the blend door actuator?
The blend door is controlled by a blend door actuator, which can be a cable or an electric motor . The blend door is also referred to by some car makers as an air mix door. Both terms mean the same thing.
Can we calibrate an actuator?
Ensure the Air Base or Actuators are not updating. Press the button on top of the actuator. In the periphery right click on the actuator and select “Calibrate Device” this can take up to 20 seconds to happen and you will hear the actuator start to move in its calibration cycle.