How much is a Porsche 911 oil change?
The average cost for a Porsche 911 oil change is between $448 and $469. Labor costs are estimated between $42 and $53 while parts are priced between $406 and $416. This range is based on the number and age of Porsche 911’s on the road.
How much does Porsche charge for an oil change?
A Porsche oil change costs between $300 to $400 at a Porsche dealership. Expect an independent mechanic to charge you around $200 to $250. However, if you are somewhat handy, you can do-it-yourself (DIY) for less than $100.
When to change oil on Porsche 911 Carrera?
Oil change Porsche 911 Carrera. The engine oil has to be changed regularly at the intervals listed in your Maintenance Schedule.If you suspect an oil leak in the engine have your dealer check it out immediately.
How often should a Porsche 911 Carrera 991 be serviced?
Additional Maintenance Every 60K or 6 years: 1 Replace PDCC reservoir 2 Replace drive belt 3 Replace all-wheel drive controller oil (4wd) 4 Replace PDK clutch fluid 5 Clean throttle body
How big is the oil in a Porsche 911?
Oil capacity: 7.9 quarts (for all non-turbo and non-GT3 models)
Where is the oil pressure sensor on a Carrera 4?
Location of Oil Pressure Sensor – 996 Series (Carrera, Carrera 4, Carrera 4S, Targa) – RennTech.org Community The last few weeks, when driving hard and exiting a corner the message Indicator Failure lights on the OBC and the oil pressure indicator goes to 0.
Oil change Porsche 911 Carrera. The engine oil has to be changed regularly at the intervals listed in your Maintenance Schedule.If you suspect an oil leak in the engine have your dealer check it out immediately.
How much oil is in a porshce 911?
Since we drained about 7.3 L of oil, we added roughly 7.4 L of new Mobil-1 0w-40. When finished, we re-installed the oil filler cap. 21. In a well ventilated area, we started the car and allowed the engine oil to heat to operating temperature (around 180 F ).
How do you do an oil change on a 911?
Next, the new sealing O-ring was installed by gently rolling the new O-ring onto the oil filter cover cap. Be sure that the sealing O-ring is put in the same position as the old one was. Beware not to push it on too far. 16. The oil filter cover cap was re-installed by hand tightening in the clockwise direction.
What’s the operating temperature of a Porsche 911?
In a well ventilated area, we started the car and allowed the engine oil to heat to operating temperature (around 180 F ). It does take a while on these Porsches to warm up, so we did apply some throttle (a couple thousand RPM increase over idle) to warm up the engine.