How much does it cost to replace rear drum brakes?
Replacing rear drum brakes (shoes, drums and hardware) in an average car in a repair shop costs from $420 to $750 per axle. Brakes are replaced on both sides at the same time. Drum brake in a car. If you plan on changing your drum brakes yourself, make sure to follow manufacturer’s instructions and safety precautions.
Are there disc brakes on the rear axle?
The majority of modern vehicles have disc brakes, however some vehicles use drum brakes on the rear axle. Rear drum brakes also function as parking brakes. Rear drum brakes. The parking brake mechanism is connected to the rear drum brakes via parking brake cables.
What causes rear drum brakes to engage too soon?
If the parking brake system is not de-adjusted properly before the brake shoes are adjusted it will cause the rear brakes to engage too soon. This is especially true of vehicles equipped with duo-servo rear drum brakes (see Figure 61.1).
What’s the best way to replace a brake line?
The replacement line will need to fit back into the same clips. Remove pipes from underneath the car. Once all of the connections are loose, you can pull the brake lines out from under the car. This will make it easier to measure out and cut the appropriate amount of brake line from your roll.
How do you replace rear drum brakes?
Steps Put on an asbestos respirator. Remove the hubcap and loosen the lug nuts. Spray the hub of the wheel with a penetrating oil such as PB Blaster. Grab the brake drum by the edges and pull it off. Note: some brake drums are held on with screws so you will need to remove those first. Once the drum is off take a look at it.
When to replace drum brakes?
Most car mechanics and makers say you should replace your car’s drum brake lining when it has worn down to about 1/8 inches or less. You can tell when this happens by measuring the lining with a tape measure. You should plan on having to replace them about every 12,000 miles, or a year of use, whichever comes first.
When to change your brake drums?
A brake drum with heat cracks, gouges severe hot spots, or that exceeds the specification limit should be discarded and replaced with a new drum. If you are within spec, these drums can be machined or “turned” at a machine shop.
How do you change rear brake pads?
How to change your rear brake pads. Support the car on jackstands and remove the wheel. Clean the brakes and remove the caliper. Remove the pads from the caliper and examine the disc and brake line (s) Insert the new pads and replace the caliper and any necessary clips. Check the brake fluid.