How much does it cost to repair a p0301 Mercedes Benz?
The cost of diagnosing the P0301 MERCEDES-BENZ code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What does the p0301 code on my car mean?
The P0301 code means that the cylinder 1 is misfiring or is randomly misfiring. Start by checking for intake leaks and if no leaks are found the next step is to replace the spark plugs on cylinder 1. If the problem persists more tests needs to be done to diagnose problem, see “Possible Causes”
What is the OBD2 code for a Mercedes Benz?
Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles. Transmission shift lever control module – supply voltage low .
What are the fault codes for Mercedes airbags?
Call us at 888-779-9029 M-F 9-5 EST Review the table below for information on Mercedes airbag fault codes: The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension.
Can you erase a fault code on a Mercedes Benz?
Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS This is diagnostic scanner used at Mercedes-Benz dealerships.
Call us at 888-779-9029 M-F 9-5 EST Review the table below for information on Mercedes airbag fault codes: The cause is the cable routing under the passenger seat. The wire was dressed from the factory such that the cabling to the connector was under tension.
What are all the codes on a Mercedes Benz?
Use an advanced OBD-II code reader to read and erase Engine CEL, Transmission, ETS, ABS, Airbag and other systems. There are also codes for other control units such as transmission, ABS, SRS, ESP, 4ETS, airbag, A/C. Mercedes-Benz can have up to 47 control units. You can NOT diagnose them with a simple OBD-2 scanner.
How to update Mercedes-Benz Collision Prevention Assist?
Clean the bumper by removing any dirt on the bumper or on the cross member that is mounted near the radiator. Ask the dealer to perform a software update for the Collision Prevention Assist Module. Locate a Mercedes-Benz dealer near you. Call them and provide your VIN.