How much does it cost to get wheel bearings installed?
The average cost for wheel bearing replacement is between $326 and $367. Labor costs are estimated between $157 and $198 while parts are priced at $169. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How to remove front wheel bearings from SLK R170?
Remove hub Pull out the outer bearing and grab the hub with both hands and remove it. You shouldn’t have to use much force, it will easily come out. Inspect the spindle and bearings Once you remove the hub inspect the old bearings and the spindle.
How to replace front wheel bearing on Mercedes C Class W202?
Instructions on how to replace bad wheel bearing Mercedes-Benz C-Class W202. Prepare Set the emergency brakes. Lift vehicle. Place jack stand supports under the car. Loosen the lug nuts. Remove front wheel. Remove the lug nuts and remove the front wheel. Undo the wheel nuts and remove the wheel.
How do you change a front wheel bearing?
Add grease Use the high-temperature grease to coat the new bearing. Pack the hub with grease as well. Add grease to needle bearing and make sure it is packed with grease. Make sure to pack the bearing with grease. It is better to have more than not enough grease.
How much does it cost to replace a wheel bearing on a Mercedes?
Wheel bearing replacement cost can range from $250 to $500. It varies greatly by your location and the local repair shop rate. Replacing one wheel bearing should not take more than 2 hours. Or at least that’s how long it took us to replace it on a Mercedes-Benz E-Class.
What’s the best way to adjust a bearing?
Grasp the wheel or hub assembly at the 3 o’clock and 9 o’clock positions. Push and pull the wheel end assembly in and out while oscillating the wheel approximately 45 degrees. Stop oscillating the hub so that the dial indicator tip is in the same position as it was before oscillation began. Read the bearing end play as the total indicator movement.
How do you pre load a wheel bearing?
While rotating the rotor to ensure proper seating of the rollers, induce pre-load by using a torque wrench to tighten the adjusting nut to 50-foot pounds. Then loosen the adjusting nut one full turn. At the same time, you need to continue to rotate this rotor, re-torque the nut, this time to 10-foot pounds.
Instructions on how to replace bad wheel bearing Mercedes-Benz C-Class W202. Prepare Set the emergency brakes. Lift vehicle. Place jack stand supports under the car. Loosen the lug nuts. Remove front wheel. Remove the lug nuts and remove the front wheel. Undo the wheel nuts and remove the wheel.
What to use to adjust tapered roller bearing?
Step 1:Lubricate the tapered roller bearing with clean axle lubricant of the same type used in the axle sump or hub assembly. NOTE: Never use an impact wrench when tightening or loosening lug nuts or bolts during the procedure.