How much does it cost to fix a p0301 Honda code?
The cost of diagnosing the P0301 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0301 HONDA code detected? Engine Cylinder 1 is misfiring. When a misfire occurs, engine speed will fluctuate.
How to know if my Honda Accord p0301 is a misfire?
1 The P0301 Honda trouble code will trigger the Accord’s service engine soon light. 2 The vehicle itself may begin to run rough. It depends on how serious the misfire is. 3 The vehicle may produce excess vibration, especially at lower RPM. 4 Fuel mileage will suffer.
What is the diagnostic code for a Honda check engine light?
Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. P1201 Cylinder 1 Misfire – Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301
What does p0301 mean on a Dodge Avenger?
It will often be accompanied by codes P0302-P0308. These particular codes indicate that there is a misfire in one of the other respective cylinders. Fixing P0301 should be a high priority. Driving with a misfire can damage that catalytic converter, and raw fuel will pass through the cylinder into the exhaust.
Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. P1201 Cylinder 1 Misfire – Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301
What does the blinking on a Honda control unit mean?
The LED indicates a system failure code by its blinking frequency. The control unit LED can indicate any number of simultaneous component problems by blinking separate codes, one after another.
Where is the fault code reader located on a Honda?
In order to retrieve any stored DTC’s, either a fault code reader must be connected to the vehicle’s data link connector (located above the Service Check Connector), or read from the MIL in the instrument cluster. The service check connector (2-pin) is located under the dashboard, above the passenger side kick panel.
Where is the check connector on a Honda Civic?
To access the DTC memory, connect a jumper wire between the check connector terminals. On Accord and Civic models, the check connector is located under the RH side of the instrument panel. On 90–91 Prelude models equipped with 2.1L engine, the check connector is located in the engine compartment.