How many quarts of transmission fluid does a 2008 Pontiac g6 take?
The transmission oil capacity after an overhaul is 9.5 quarts. If you are servicing the transmission then expect to use less than 5 quarts, unless you’re having a transmission fluid exchange with a fluid exchanger at a shop.
How can I check the transmission fluid level?
Wipe the transmission fluid level indicator clean. Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. 6. Using the scan tool, verify that the transmission fluid temperature is between 80°C-85°C (175°F-185°F).
What should the temperature of the transmission fluid be?
Using the scan tool, verify that the transmission fluid temperature is between 80°C-85°C (175°F-185°F). Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark.
Where is the dipstick for automatic transmission fluid?
Check owner’s manual.) Locate automatic transmission fluid dipstick, typically near where the transmission or transaxle meets rear of the engine. It looks similar to the oil dipstick. Remove automatic transmission fluid dipstick. Wipe clean, reinsert fully and remove again. CAUTION: FLUID MAY BE HOT! Observe markings at end of dipstick.
What happens if your transmission fluid is dirty?
Dirty fluid can cause issues ranging from a check engine light to damaged transmission internals. Heat and broken parts will shorten the life of your fluid, but in general, your transmission fluid will last the life of your truck.
Wipe the transmission fluid level indicator clean. Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. 6. Using the scan tool, verify that the transmission fluid temperature is between 80°C-85°C (175°F-185°F).
How to check the transmission fluid in a corvette?
1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open 3. Remove Dipstick – Access point for transmission fluid 4. Check Level – Insert dipstick and pull it out to determine level 5. Add Fluid – Determine correct fluid type and add fluid 6. Replace Dipstick – Put the dipstick / cap back in place 7.
How to check transmission fluid levels in a 2008 Saturn?
Look to the left of the bottom most transmission to engine mounting bolt to locate the transmission fill plug. Start the engine and allow it to reach operating temperature, the transmission fluid must reach a minimum of 104 degrees to accurately check the fluid level.
How to check the transmission fluid in a Buick Enclave?
Transmission Fluid Level Check Buick Enclave (2008-2012) 1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open 3. Remove Dipstick – Access point for transmission fluid 4. Check Level – Insert dipstick and pull it out to determine level 5.