How many quarts of oil does a 2009 Jeep Commander take?
5 quarts
Capacity: 5 quarts (with filter)After refill check oil level.
How much oil does a Jeep Commander 3.7 take?
5 quarts (with filter)After refill check oil level.
What kind of oil does a 2010 Jeep Commander take?
5W-20
Engine Oil
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 5 quarts. . . (with filter)After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) |
What oil does a 2008 Jeep Commander take?
Engine Oil
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 7 quarts (with filter)After refill check oil level. |
| Torque: | 20 ft/lbs (Oil Drain Plug) |
What kind of oil does Jeep Commander use?
Mobil 1 Extended Performance Synthetic Motor Oil 5W-20 5 Quart.
How do you reset the oil light on a 2009 Jeep Commander?
How To Reset Jeep Commander Change Oil Light in 3 Easy Steps!
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
When to change oil on a jeep 3.7L?
You’ll need it for your torque wrench to torque them down properly later, anyway. The FSM says to change the oil when its hot, to idle the motor until its at full operating temp. Have an old towel, you will spill fluid, there is no way around it unless you find a 3 ft wide catch pan.
How entailed is transmission fluid change on 3.7L?
Probablly easier to just have the deal do it. I just did the fluid & filter change on my 3.7L Commander, its a NAG1/W5A580 trans. Its a Mercedes trans, there is a Mercedes designation as well, 722.3 or 722.6, NOT sure on that number.
How much fluid does a 3.7L Jeep have?
One of the 6 retaining lugs also attaches to a cover of the electronics, remove that bolt before dropping the pan or you’ll bend up the cover slightly. The FSM will say the pan holds 7.4 qts and to fill with 7.4 qts after dropping the pan.
How do you check the fluid level on a jeep?
You check fluid level with a special tool, that is just a dip-stick with a really nice scale on it, and the temperature of the fluid and adjust fluid level off a chart. The procedure is too use the dealer tool to read the trans computer reading the temp, which is probably the most convenient for the dealer mechanic.