How many brake warning lights does a Porsche 928 have?
This article applies to the Porsche 928 (1979-1995). The 928 actually has four different brake warning lights – the brake fluid light, the brake pad light, the brake pressure light, and the ABS light for the last year. The first thing you need to do is determine which light is on and go from there.
Why does the brake light go away on my Ford 928?
The first thing to do is check your pads. The 928 has a tiny sensor in each of the brake pads designed to let you know when your pads are getting low. If the system is working properly, replace the pads and the light will go away as intended.
How to replace brake fluid in a Porsche 928?
(Related Article: Porsche 928: How to Replace Brake Fluid – Rennlist.com) Figure 1. 928 Master cylinder and reservoir that could use a bit of cleaning up. The first thing to do is check your pads. The 928 has a tiny sensor in each of the brake pads designed to let you know when your pads are getting low.
This article applies to the Porsche 928 (1979-1995). The 928 actually has four different brake warning lights – the brake fluid light, the brake pad light, the brake pressure light, and the ABS light for the last year. The first thing you need to do is determine which light is on and go from there.
How are the brakes assembled on a Porsche 928?
It is a thin low viscosity liquid, and the mechanic just put a few drops over the entire surface of each pad and let it soak in for a while. It went on the friction material side of the pad, not the backing. The brakes were assembled without the usual round anti-squeal disks. Just pad against the piston.
Can a Porsche 928 be converted to LEDs?
Converting Porsche 928 Interior Lighting to LEDs 7 a higher voltage at their cathode than their anode. Discrete LEDs should be used with care, as they can be easily destroyed in two ways: reverse biasing them or exceeding their rated maximum drive current.
Where are the ground wires on a Porsche 928?
One is at the top of the “O” in the word Porsche cast into the cam cover — and it may be covered-up by the emissions air injection valve/hose. The second attachment point on the cam cover is more visible and is closer to front of car. Point 10 For later Euro cars, look for ground wires attached to the back of cam gear metal rear covers.