How long does it take to fix a tachometer on a 1979 Camaro?
fix it in 5 minutes with less than $5 for the single part you need! click here forSpecial edition of this page for 70’s and 80’s GM truck tachs When I bought my 1979 camaro the tachometer was reading about two and a half times what it should have.
Why is my tachometer not working on my 1975 Corvette?
On 1975-76 Corvette tach the printed circuit board usually show a burned spot, actually melts the thin copper wire and the problem is obvious. 1977 to 1982 circuit boards don’t , and you can’t tell by looking at it. 2.
Is there a problem with my GM tachometer?
I did some research and found this is an extremely common problem on GM cars made in the 70’s and 80’s on anything from camaros and firebirds to fieros and corvettes. I found some sites about fixing the problem but I had to compile information from 3 or 4 before I knew enough to fix mine.
What does it mean when the tachometer needle goes to zero?
If the needle goes to zero this indicates the tach is working and 12 volts and ground are present. If the needle does not move,either the circuit board is bad or 12 volts or ground are missing to the tach.
Can you repair a 1969 Trans Am tachometer?
TACHMAN CAN REPAIR/CALIBRATE YOUR 1969 TRANS-AM STACK TACHOMETER, SPEEDOMETER/GAUGES AND UPDATE YOUR CLOCK TO QUARTZ! 1964 G.T.O TACHOMETER UPDATE,CLOCK QUARTZ UPDATE AND SPEEDOMETER REPAIR!
fix it in 5 minutes with less than $5 for the single part you need! click here forSpecial edition of this page for 70’s and 80’s GM truck tachs When I bought my 1979 camaro the tachometer was reading about two and a half times what it should have.
On 1975-76 Corvette tach the printed circuit board usually show a burned spot, actually melts the thin copper wire and the problem is obvious. 1977 to 1982 circuit boards don’t , and you can’t tell by looking at it. 2.
I did some research and found this is an extremely common problem on GM cars made in the 70’s and 80’s on anything from camaros and firebirds to fieros and corvettes. I found some sites about fixing the problem but I had to compile information from 3 or 4 before I knew enough to fix mine.