How long do wheel bearings last on a Honda CRV?
Sealed bearings can last 100,000 miles or more, and will need to be replaced once they go bad. Vehicles with traditional, tapered wheel bearings should have them serviced every 25,000 to 30,000 miles — replacement may not be necessary as long as they’re maintained.
How much does it cost to replace a fuel pump on a Honda CRV?
The average cost for a Honda CR-V fuel pump replacement is between $728 and $863. Labor costs are estimated between $78 and $98 while parts are priced between $650 and $765.
How do you remove transmission nut on Honda CRV?
Remove the cotter pin on the bottom of the ball joint. Loosen this nut by about 1/4″, but do not completely remove it. Jam your ball joint removal tool between the control arm and your wheel hub, grab your hammer, and proceed to beat it like a rental car. This usually takes a substantial amount of effort.
How to remove a lower ball joint from a Honda CRV?
Please try again later. Honda CR-V, how to remove a lower ball joint from the control arm, when disassembling the front end of a vehicle to replace a suspension part, you need to release the tapered end of the balljoint, or tie rod end from the control arm, here is an easy way to do it without any special tools. Loading…
Where is the transmission on a Honda CRV?
The part number is 17220-PNB-003. This is at the front of the car, just behind the radiator. You are now removing the lower air intake hose. A 10mm socket will take these off. It can be tricky to remove this part, since the battery tray and wire harnesses are in in the way. Now you can remove the rest of the air box.
What is the part number on a Honda CRV?
The Honda part number is 18393-SH3-S00. The nuts are probably too rusty to work with, so replacing them is not a bad idea. They are part number 90212-SA5-003. Disconnect the two electrical connections of the exhaust, then remove the bracket holding them on.
How do you take the back seat out of a Honda CRV?
Locate all the retaining bolts holding the CRV’s rear seat to the floor. Tilt the seat forward and remove the retaining bolts with a socket wrench. Pull the seat forward and away from the bolts. Climb out of the CRV and pull the seat out through the open door. Be careful not to scratch the car while you’re pulling the seat out.
How do you replace the castle nut on a Honda CRV?
Screw on the new castle nut onto the ball joint shaft. Using a 1/2 socket wrench, torque down the castle nut and align the nut with the cotter pin hole in the ball joint shaft.
What should I do about my Honda CRV front suspension?
2002-2006 Honda CRV front struts with sway/stabilizer bar links. 2002-2006 Honda CRV control arms and ball joints. Here is a list of the special tools you’ll need for this project. The short video below shows you these tools in action.
Can a ball joint be removed from a Honda CRV?
Because the old ball joint is press-fitted into the steering knuckle under high pressure, you will generally need a ball joint press plus a Honda-specific ball joint removal and installation tool in order to remove and install the ball joint. Some ball joint service tool kits do have adapters that work with Honda ball joints.