How long do Polaris drive belts last?
If maintained properly, belts can last between 3000-5000 miles.
When to replace the belt on a Polaris Ranger 500?
If a belt fails on your Polaris RANGER 500, always clean any debris from the clutch air duct and from the clutch and engine compartments when replacing the belt. Failure to remove all debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death. The replacement belt is part number 3211169.
Is there a warranty on Polaris Drive belts?
While Polaris offers an extended belt warranty on their vehicles, this warranty only applies to failures that result from a manufacturer’s defect in the construction of the drive belt. Upwards of 98% of belt drive failures result from misuse, abuse, and a lack of maintenance, and none of these failures are covered by the drive belt warranty.
How long does it take to change drive belt on Polaris Magnum?
This project should take 30 minutes to an hour depending on your skill level and tools. The drive belt on Polaris atvs is the equivalent of a clutch. This particular atv is a Polaris Magnum 330, but all are pretty much the same.
How do you change clutch on Polaris Ranger?
Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4. Pull the bottom of the cover outward and over the suspension to remove it.
How do you change drive belt on Polaris Ranger?
The replacement belt is part number 3211169. Follow these steps to replace your drive belt: 1. Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4.
Position the vehicle on a level surface. Block the wheels to prevent vehicle movement. Place the transmission in neutral. 2. Lift the cargo box. 3. Remove the clutch cover (1) using a 3/8-inch socket with ratcheting wrench and extension. 4. Pull the bottom of the cover outward and over the suspension to remove it.
What happens if the belt fails on a Polaris Ranger 500?
If a belt fails on your Polaris RANGER 500, always clean any debris from the clutch air duct and from the clutch and engine compartments when replacing the belt. Failure to remove all debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death.
Where can I buy a 1999 Polaris Ranger?
Dennis Kirk has been the leader in the powersports industry since 1969, so you can rest assured that we have your back when it comes to bringing you the best 1999 Polaris Ranger 500 6×6 products. You’ll enjoy our no-hassle return policy and all orders over $89 receive free shipping, so you can shop with complete confidence at Dennis Kirk!