How hard is it to replace a stator on a motorcycle?
Replacing the stator is not too complicated and requires a socket set and some heat resistant gasket repair silicone only. On 2006-07 Honda Fireblades the stator is located on the left hand side behind the crash protector.
How to replace stator and regulator on Harley Davidson Sportster?
Harley Davidson Sportster: How to Replace Stator and Regulator. The Sportster has an electromagnetic stator, a rotor that spins around it to produce AC power, and a regulator/rectifier that turns it on and off as needed to charge the battery, and converts the AC to DC.
Can a stator be replaced on a twin cam Harley Davidson?
In this video, Mike walks us through the process of a full charging system test, along with the removal of a complete charging system on a Twin Cam touring model. He demonstrates the stator replacement with a 50 amp upgrade. This upgrade will keep your battery up to snuff as the demands on the battery and charging system keep growing.
How to install a stator on a Harley Davidson Soft Tail?
Unplug the voltage regulator from the motorcycle’s wiring harness, then pull the voltage regulator away. Mount a new voltage regulator onto the engine, then place the ground wire terminal over the right mounting post. Screw the mounting nuts into place and tighten them to 100 inch-pounds. Plug the voltage regulator into the wiring harness.
How to replace the rotor shell on a Harley Davidson?
This three-part video series walks us through Harley Davidson charging system replacement. Bob LaRosa shows us how to replace the Harley stator and rotor shell.
Harley Davidson Sportster: How to Replace Stator and Regulator. The Sportster has an electromagnetic stator, a rotor that spins around it to produce AC power, and a regulator/rectifier that turns it on and off as needed to charge the battery, and converts the AC to DC.
In this video, Mike walks us through the process of a full charging system test, along with the removal of a complete charging system on a Twin Cam touring model. He demonstrates the stator replacement with a 50 amp upgrade. This upgrade will keep your battery up to snuff as the demands on the battery and charging system keep growing.
How do you replace a stator on a cable?
Loosen the four bolts holding the stator to the cases. Before you pull the stator off, tie a string to the end of the cable by the regulator. Pull the string through the hole in the cases as you remove the stator. Install the new stator and pull the new cable through with the string you left behind.
How to replace the shifter on a Harley Davidson Sportster?
Remove the shifter and linkage by removing the pinch bolt and prying it off. Drain the primary oil and remove the primary cover. Some cover screws are longer than others, so keep track. If you forget, the manual shows which go where.