How does carb synchronization work on a motorcycle?
After cleaning, repairing, and reassembling your carburetors, you’ll need to balance and synchronize them. A complete carb synchronization typically starts off the bike with a static carb bench synch followed by a vacuum sync with a carb sync tool after the engine is warmed up.
How to adjust the CARB mixture on a Yamaha?
Set idle to an RPM that is low but still steady — about 1000 RPM if you have a smooth-running bike. Now go to the right-side carb and screw the mixture screw in in half-turn increments until the engine starts running slower. Now, turn the mix screw out in half turn increments.
How to sync the CARB on a Yamaha XS650?
Yamaha XS650 Carb Sync: Remove the vacuum plugs from the carb body and attach the hoses from your vacuum gauge. Start the motorcycle and bring it up to operating temperature. Adjust the dampers in each vacuum hose until the needles only move slightly. Turn the sync crew until the gauges return the same reading.
What should choke clearance be on CB750 carb?
Remove the fuel tank and set up an auxiliary tank or a long fuel line to the carbs. Remove the air cleaner to confirm proper operation of the choke butterfly valves. If the clearance between the choke valve and carb body is greater than .5mm, adjust the choke clearance by lengthening or shortening the choke lever adjustment rod.
Remove the fuel tank and set up an auxiliary tank or a long fuel line to the carbs. Remove the air cleaner to confirm proper operation of the choke butterfly valves. If the clearance between the choke valve and carb body is greater than .5mm, adjust the choke clearance by lengthening or shortening the choke lever adjustment rod.
How is the CARB adjusted on a Honda motorcycle?
The carburetor adjustments include idle speed, idle circuit mixture, mid-range and high-speed circuit mixture. The idle circuit and idle speed is adjusted with a screw. The mid-range and high-speed mixture is controlled by changing jet size in the carburetor bowl.
Yamaha XS650 Carb Sync: Remove the vacuum plugs from the carb body and attach the hoses from your vacuum gauge. Start the motorcycle and bring it up to operating temperature. Adjust the dampers in each vacuum hose until the needles only move slightly. Turn the sync crew until the gauges return the same reading.
How to adjust carb sync on a CB750?
With the bike on its center stand and the fuel petcock running, hold the clear tube next to the carb body and record where the fuel level sits. Adjust as necessary by removing the float bowl, and adjusting the small metal part of the float that sit on the needle. Make tiny adjustments and be careful not to bend the floats.