How do you turn off the oil light on a Volkswagen Jetta?

How do you turn off the oil light on a Volkswagen Jetta?

How to Reset Oil Light: Volkswagen Jetta 2011-2016

1. Turn the ignition off.
2. Press and hold the 0,0 button (located to the right of the instrument cluster).
3. Turn the igntion on (do not start the engine) and release the 0,0 button.
4. Briefly press the double square button (located to the left of the instrument cluster).

How do I turn off the light after an oil change?

Hold the Reset Button and Turn the Key

1. Press and hold the reset button.
2. Turn the ignition back to the ON position while holding the reset button.
3. Watch the oil change or maintenance light carefully.
4. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How do you reset the oil light on a 2020 Jetta?

Press and hold the OK button on the multi-function steering wheel for about 4 seconds and then release. The Service menu appears in the instrument cluster display. Push the arrow up and down buttons and select either the Reset Oil Service or Reset Inspection.

How to reset VW Volkswagen Jetta oil service Minder light?

If you exceed the specified service interval, the Service minder Light will blink and you should reset the service interval. Perform the following step to reset service light on your VW Volkswagen Jetta: Do not start the engine! Turn off the ignition and start the engine and verify the indicator has been reset. Done!

How to turn off service oil life light?

To turning off the Service Oil Life Light on later models of VW Jetta (2015), conform to the following instructions: Press and hold the trip-odometer button “0.0”, and turn the ignition switch to the “On” position, but do not start the engine.

When does the oil light come on on a VW?

This sensor is for the oil light only (no flashing or buzzer). This is the same sensor that has been used on VWs for the past 30 years. It senses when the oil pressure falls below .2 bar (around 3 psi). At this point the sensor grounds itself and the light comes on.

Why is the oil light blinking on and off?

As we have said the sensor tells the buzzer and light to come on when the control board sees an open in the circuit. This could be caused by the sensor or it could also be caused by the wiring going to the sensor if it becomes broken somewhere along the run.