How do you troubleshoot a headlight on a motorcycle?
Start by removing the headlight. At the back of the headlight, you will see a plug. Follow the wire that connects to the plug. As it makes it way to the wiring loom, look for any broken or exposed pieces of wire. Examine the plastic pieces around the headlight plug and bulb.
Is there a headlight on a Harley Davidson?
No headlight, light bar but front fender lights up . speedo lights up, not fuel gauge.wont crank, wont make a sound. battery checked out good. bike just wont crank . not a sound. Also no green naural light. I pull in the clutch and still grt nothin’.
Why are my lights not working on my Harley?
your bike will not start because you have no IGNITION power. the ignition power runs the starter relay, coil and ignition module. the power source for lights and ignition are 2 separate switch contacts. your lights come off the keyswitch relay.
Why does my Harley Davidson bike not start?
your bike will not start because you have no IGNITION power. the ignition power runs the starter relay, coil and ignition module. the power source for lights and ignition are 2 separate switch contacts.
What to do if your Harley Davidson won’t start?
Harley Davidson Sportster: Why Won’t My Bike Start? 1 Test your starter. Refer to Step 4 of the article Electrical Diagnostic Guide for information on starter testing. 2 Check for fuel. If your bike cranks but doesn’t start, the first thing to check is the fuel supply. 3 Check for spark.
What should the current be on a Harley Davidson starter?
In addition to the starter current draw test, you can measure the voltage at the wire connected to the starter solenoid from the ignition switch. With the ignition in the on/run position and the button pressed, 12 volts should be present at this wire.
What does it mean when your motorcycle won’t start?
There are few things that are more disappointing than getting psyched up to go riding only to be hit with realization that your motorcycle won’t start. The engine is turning over, but nothing is happening except for the fact that your frustration level is rising.
What should the Kill Switch reading be on a Harley Davidson?
Measure the resistance/continuity of the switch with the button pressed by placing each multimeter lead at opposite ends of the switch. The reading should read less than 0.1 ohms. If the reading is higher or “OL,” you need a new switch. The kill switch is connected to the ignition coil and ground.