How do you torque primary clutch bolts?
Torque it up, then raise the rear of the sled and run it up to 30 MPH. Slam on the brake. Repeat this 2 more times then re torque the bolt.
What is the torque on a Polaris primary clutch?
80 ft/lbs
Hold the primary clutch using a clutch holding tool (SLP #20-202) and torque the primary clutch retaining bolt to 80 ft/lbs (130 Nm).
Can Am x3 primary clutch bolt torque?
74 pounds for the primary, and 44 pounds for the secondary.
Can Am X3 primary clutch bolt torque?
What are the torque specs for the primary clutch?
Service manual torque specs for the drive (primary) clutch mounting bolt is 96 ft-lbs; torque specs for the drive clutch spider is 290 ft-lb (Apply 0.4 mL Loctite® 620™). SOLD!!! 2012 RZR 570, with most of the accessories. ? Bought!!! 2015 RZR S900 Titanium! Let the fun begin (again)!! XP1K wheels and tires. XB3 fire extinguisher, in cab.
What’s the torque spec for a Rasty team clutch?
Yep, both supposed to be 60 ft-lbs. Secondary supposed to have red Loctite. Primary is 60, secondary is 35. Thats from Trail manual but id say since both are Team clutches the spec would be the same. I believe Rasty has a Wildcat 1000, so that’s the torque spec I quoted from the service manual.
How big is the primary clutch on a snowmobile?
55 Ftlbs for the primary bolt. Make sure you check it after about 5 min of running. Also make sure that the clutch and the motor are at ambiant temp. I don’t think I’ve ever changed a secondary spring while on the sled. Better off taking the clutch off now before the snow flies!
Do you put Loctite on Polaris clutch bolts?
In 14 years of doing clutching I never torqued those 6 bolts and never put loctite on them, they don’t have loctite from Polaris either. For that matter I have never torqued the main bolts holding the clutches on either, use a 18v milwaukee and know when to quit.
What are torque specs for primary and secondary clutches?
I have read the posts about replacing the ‘stretching’ bolts in both the primary and secondary clutches. I found good quality bolts and read your required torque settings of 89 and 44 ftlbs, do you use any kind of lock tight on those bolts? What blots did you buy. Grade 8 or grade 10 socket head bolts????
When to use a new secondary clutch bolt?
recommends using a new secondary (driven) clutchbolt every time the bolt has been removed. Can-Am’s torque procedure for the new secondary (driven) clutch bolt is: Step 1 torque bolt to 15 ft/lbs +/- 1ft/lbs. Step 2 tighten; 180 degrees +/- 5 degrees. Step 2 – Tighten retaining nut another 180 degrees +/- 5 degrees.
Do you need torque specs for a hooker?
I {Heart} Hookers. You need a manual, as you need torque specs for the entire assembly of the primary cover, inner primary bolts, clutch hub nut, compensator, starter bolts, starter jackshaft bolt, swingarm pivot bolts and rear axle nut. 1.)
What are the torque specs for Grade 8 socket head bolts?
Grade 8 or grade 10 socket head bolts???? If you bought grade 10 I do 100# on primary and 50 on secondary. As for lock tight 1 drop. I don’t use loctite on ether. But if it make you feel better by all means use it.