How do you take the radio out of a Jeep YJ?
Drop the door down as far as possible. Reach behind the radio by sticking your hand behind the right side of the radio through the glove box. Use a 10-mm wrench to remove the nut holding the back of the radio. Pull out the radio, unplug the harnesses and antenna and remove it from the dash.
What is pink wire car stereo?
The memory wire is a constant feed to your stereo, allowing it to retain stored information. If you have a new radio fitted and it forgets your presets when you turn the ignition off, the chances are that this wire is the culprit. This wire is also necessary for you to use your radio with the ignition off.
What’s the difference between a YJ and a TJ Jeep?
The biggest and most obvious difference between the YJ and the TJ is the suspension. While the YJ had a leaf spring design, Jeep gave the TJ a coil spring suspension design that was based on the Grand Cherokee’s suspension. Much like the YJ the TJ came standard with the 2.5L, and the optional 4.0L.
How to install an aftermarket radio into a 1996 1998 Jeep?
If the factory radio in your 1996-1998 Jeep Grand Cherokee is old, out-of-date, or just not working correctly, you can replace it with a brand-new aftermarket radio yourself. Open your Jeep’s hood and disconnect the negative (-) battery terminal off of your Jeep’s battery.
Where are the radio bolts on a jeep?
A bolt is located in the upper right-hand corner of the factory radio, and another bolt is located in the lower left-hand corner of the factory radio. Set these aside, as you’ll need them later.
What kind of sound system does a jeep have?
If your Jeep has the factory Infinity Gold premium sound system (Infinity Gold logo on both front door speaker grilles), connect the blue wires together for the remote amplifier turn-on wire. If your Jeep does not have the factory Infinity Gold premium sound system, then cut off the bare end of the blue remote amplifier turn-on wires.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.