How do you start a jetmaster gas fire?
Remember to shut the gas supply valve off (picture #1). If it remains lit, press the valve knob in slightly and rotate counter- clockwise until the word “ON” is in the 6 o’clock position. Finally, turn the unit’s ON/OFF switch (or wall switch or remote control) to the “ON” position to start your fire.
How does a Jetmaster fireplace work?
Jetmaster fires warm the room in two ways: through radiated heat directly off the fire and through the convection technology. As the hot air leaves the unit it causes a vacuum for more cool air to be drawn through the convection chamber, creating a natural cold-to-warm circulation.
How do you light a Jetmaster gas fireplace?
Locate control knob on right hand side of valve. Depress and turn control knob (FIG 1) to the PILOT position (FIG 4). Depress the control button and ignite with piezo ignitor (FIG 2) whilst keeping control knob firmly depressed for 20 seconds. Check that pilot stays lit.
What is the lever on the side of my fireplace for?
The second handle you may find in your fireplace (usually located on the left inside panel) is a control lever for the outside air kit. When burning your fireplace, the outside air kit lever should always be in the open (or up) position. The outside air kit is designed to provide additional air for combustion.
Should the pilot light always be on in a gas fireplace?
Should the pilot light always be on in a gas fireplace? Most gas fireplaces rely on a “continuous pilot light,” a type of pilot that remains lit so long as gas is flowing to the unit. If you have a continuous pilot light system, you should always see a pilot flame unless you have manually turned the system off.
How do you light a jetmaster?
How to install a gas log on a Jetmaster 850?
Installation Instructions Jetmaster 850 Gas Log Ceramic Log Positioning for Gas Fires 1. LOCATE 4 CERAMIC COALS:Four ceramic coals are supplied with the burner base.These coals must be laid in the position indicated on the drawing with the taller coals on the ends and smaller coals in-between.
Where do you drill a hole for a Jetmaster fireplace?
In an existing fireplace or Jetmaster firebox (if being used) drill a 15mm hole through the right hand side of the fireplace(as you face it) at a point of 85mm from the base and 85mm from the rear wall(if providing stop cock in firebox).85mm from front wall (if stop cock is outside firebox). 4.
What are the specs for a Jetmaster hearth?
Summary of Minimum Jetmaster Installation Specs Summary of Minimum Jetmaster Installation Specs 1. HEARTH 2. FLUE Must be constructed from a non combustible material such as concrete, brick, or autoclaved • Single skin flue (stainless steel) must be enclosed with single skin brickwork, aerated lightweight concrete block.
What should I use to clean my Jetmaster firebox?
Use lugs and bolts provided and attach to flange on firebox. General Maintenance The visible parts of your Jetmaster can be cleaned with a damp cloth or soft brush. Should you wish you could repaint the unit with a heat resistant paint. Universal 440 Universal 500 Universal 600 Universal 600 low Universal 700 sh Universal 700 sh low