How do you reset the TPMs on a Pontiac?
Using the keyless entry (key fob), press and hold the lock and the unlock buttons simultaneously until the horn sounds. Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR.
How long does it take to relearn the ignition switch?
When performing this relearn, all previously learned keys will be erased. Additional keys may be relearned immediately after the first key has been learned by inserting the additional key and turning the ignition switch to on within 10 seconds of removing the previously learned key. Turn key to the “ON” position without starting the engine.
How does the TPMS scan work on a GMC?
Using the keyless entry (key fob), press and hold the lock and the unlock buttons simultaneously until the horn sounds. Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR. The horn will chirp, after the vehicle has received a signal from each sensor.
What’s the relearn procedure for a GM PassLock?
The Passlock family has two basic relearn procedures—a ten-minute procedure and a thirty-minute procedure—and which one you use depends on the system and what components have been replaced. The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing.
How to clean the throttle of a Pontiac G6?
3. Clean the throttle body bore and the throttle valve plate using a clean shop towel with ETech Chemicals ET110 Throttle Body Cleaner. 4. Install the air intake duct. Refer to Air Cleaner Inlet Duct Replacement. 5. Perform the Throttle Learn Procedure.
Using the keyless entry (key fob), press and hold the lock and the unlock buttons simultaneously until the horn sounds. Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR.
When performing this relearn, all previously learned keys will be erased. Additional keys may be relearned immediately after the first key has been learned by inserting the additional key and turning the ignition switch to on within 10 seconds of removing the previously learned key. Turn key to the “ON” position without starting the engine.