How do you reset the TPMS light on a 2005 Jeep Liberty?
On 2005-06 models, drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 20 mph. On 2007 models, drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 15 mph.
Where is the TPMS reset button on a Jeep Liberty?
Depress the TPMS reset button located below the steering wheel until it blinks three times. Turn the ignition off and remove the key. Start the engine and let it run for 20 minutes while the system records the new pressure of each tire.
What is Jeep Liberty TPMS?
The Tire Pressure Monitor System (TPMS) uses wireless technology with wheel rim mounted electronic sensors to monitor tire pressure levels. Sensors, mounted to each wheel as part of the valve stem, transmit tire pressure readings to the receiver module.
Does 2006 Jeep Liberty have TPMS?
US 2006 Liberties came with TPMS on all 5 wheels. There are two different systems. One for vehicles with EVIC and one for those without. The sensors in the wheels are the same.
How do you reset the TPMS light on a 2006 Jeep Liberty?
Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely.
What PSI should Jeep Liberty tires be?
Recommended tire inflation for Jeep Liberty Sport is 33 psi for front tires and 33 psi for rear tires.
Where are the sensors on a jeep TPMS?
Sensors are mounted to each wheel as part of the valve stem. Each sensor sends data to a central receiver circuit inside the Wireless Control Module (WCM). On premium models, the sensor transponders are mounted in the wheel housings.
How often does a jeep TPMS indicator light flash?
Once the vehicle’s wheels stop rotating for 20 minutes, the sensors shut down. While in this state (Park Mode), the sensors still transmit data once every 13 hours. If a system fault is found, the indicator light will flash on and off for 75 seconds, then will stay on continuously.
How long does it take for TPMs to reset Jeep Commander?
The WCM automatically learns and stores the sensor’s IDs while driving. This is achieved by driving the Commander for a minimum of 10 minutes while maintaining a continuous speed of above 20 mph for 2006 models and 15 mph for 2007-09 models. During this time, the system will learn the new sensor ID code.
Is there tire pressure monitor on Jeep Commander?
No. The tire pressure monitoring system (TPMS) in the 2006-09 Jeep Commander uses radio and sensor technology to monitor air pressure levels. Sensors are mounted to each wheel as part of the valve stem. Each sensor sends data to a central receiver circuit inside the Wireless Control Module (WCM).