How do you reset the throttle position sensor on a Harley Davidson?
You turn the ignition on, wait 10 seconds. Then turn the ignition off, wait 10 seconds. Do this 4 times and you’re done.
What to use to clean throttle position sensor?
Once the device (sensor) is detached, you can start off with the cleaning procedure instantly. Use the cleaning solvent, something like a carburetor fluid and a clean piece of cloth, to remove the grime and dirt around the area of the TPS unit. Also ensure that the solvent that is used to clean, dries out completely.
Where is the throttle grip sensor on a Harley Davidson?
The throttle-grip sensor is keyed to the handlebar with a series of notches cut into the bar that mate with bosses on the throttle-grip sensor. The throttle-control actuator includes a geared, permanent-magnet DC motor, and two sealed automotive-style throttle-position sensors mounted to the side of the throttle body.
Is it time to replace throttle position sensor?
Now that you are sure all the surfaces are cleaned thoroughly, it’s time to put the sensor back, or if needed, go in for a throttle position sensor replacement! This job is really simple to go about.
How to adjust the throttle position sensor on a Delphi TC88?
HD Part # 27629-01 Interesting that it is used on a Delphi EFI system of the 2004 TC88. How do you go about adjusting it to 0.4 Volts?
How can I Reset my throttle position sensor?
Reprogramming or resetting your sensor can sometimes solve these issues. This step can also be necessary when you install a new sensor. The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
What causes a bad throttle position sensor to malfunction?
In short, incorrect amounts of air and fuel means problems for the engine. While the throttle position sensor makes sure the engine gets the correct amount of air, it is common for it to malfunction. Learn bad throttle position sensor symptoms now so that you can take care of this engine problem as soon as it arises.
The throttle-grip sensor is keyed to the handlebar with a series of notches cut into the bar that mate with bosses on the throttle-grip sensor. The throttle-control actuator includes a geared, permanent-magnet DC motor, and two sealed automotive-style throttle-position sensors mounted to the side of the throttle body.
How does electronic throttle control work on a Harley Davidson?
It also uses the brake input as a redundant—if you are on the brake it will drive the throttle plate to near idle. If you then lose the other Hall effect sensor signal and the electronic control module is unable to determine what the rider wants to do, it goes into a forced-idle mode.