How do you reset the power window on a 2007 Lexus RX 350?
To reset your windows push down the window half way then pull up on the window button and hold for three seconds. Do that for all window buttons and it should work.
What to do if your Mazda RX-8 won’t start?
If the lights anywhere in your car are not turning on, your battery may be dead. Check to see if you can start your engine. If the engine turns on then your battery should be working properly. However, if the engine will not start, refer to the Car Cranks But Won’t Start .
Why is the oil in my Mazda RX-8 so dirty?
As you drive the car the oil picks up impurities in the engine and can lose some of its lubricating properties. Because in the RX-8 the oil is introduced inside the engine it is even more important that the engine oil remain clean and fresh.
When did the Mazda RX-8 come out?
This category covers 2004, 2005, 2006, 2007, 2008 Mazda RX-8 Troubleshooting models. Your guide to finding the problems with your Mazda RX-8 so you can effectively and efficiently resolve them.
What to do if your RX-8 has a flat tire?
When the break pads get too low they must be replaced. The stock RX-8 does not carry a spare tire, but instead has a “fix-a-flat” kit stored in the trunk. This kit includes tire sealant and a pump that should be able to reinflate the tire for a short period of time to drive the car to a tire shop or somewhere where the tire can be replaced.
If the lights anywhere in your car are not turning on, your battery may be dead. Check to see if you can start your engine. If the engine turns on then your battery should be working properly. However, if the engine will not start, refer to the Car Cranks But Won’t Start .
Why does my Lexus RX350 won’t start?
While there are a variety of reasons your Lexus RX350 won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
Why does my Mazda RX-8 stall at 3000 rpm?
The rough idle appeared to go away after driving a long highway trip where RPM tended to remain above 3000 for long periods. I believe there are two things going on with the RX-8 AT. The engines simply need to run at least at 3000RPM to keep everything clean and clear.
As you drive the car the oil picks up impurities in the engine and can lose some of its lubricating properties. Because in the RX-8 the oil is introduced inside the engine it is even more important that the engine oil remain clean and fresh.