How do you reset the computer on a 2007 Honda Rancher 420?
hold both the up and down shift buttons and turn the switch on. then release and press up – down – up , move the throttle lever from fully closed to fully open and then back to fully closed. this all has to be done pretty fast and should here the control motor cycle.
How do you reset the service light on a Honda ATV?
Resetting Your Honda Oil Maintenance Light in 4 Steps
- Turn the ignition to run (one click before starting the engine).
- Press the Select/Reset button located on either your steering wheel or as a knob on your dash.
- Press and hold the Select/Reset button for 10 seconds.
How do you reset the service light on a Honda Rancher 420?
On the 420 with the key switch off press and hold the od/trip button and turn the key on while holding the button, will go off in a few secs.
What does the angle sensor do on a Honda Rancher?
they control the angle of the shifting shaft when it shifts gears. and they are tied to the speed sensor to tell the ecu through the display how fast your atv is moving ?, this intel, keeps the shifting motor from only shifting at certain speeds. Sensor is located in the back of Engine next to the drive shaft.
How do you reset the computer in a Honda?
1. Start the engine and let it idle about 30 seconds with the sub-transmission in the neutral. 2. Move the gearshift lever to the D position and check that the gear position indicator shows “D.” 3. Ride slowly forward for about 5 feet. 4. Move the gearshift lever back to the N position and check that the gear position indicator shows “N.” 5.
How to reset Honda Rincon ECU / PCM reset?
With the vehicle stopped, put the gearshift lever in “N” (neutral), be sure that the neutral indicator comes on and turn the ignition switch to “off”. Step 2. Turn the ignition switch to “on” while pushing the UP and Down shift switches (gearshift switches) simultaneously. The “N” on the gear position indicator starts blinking.
How to reset your Honda engine maintenance light?
If your display reads “Engine Oil Indicator %”, press and hold the Select/Reset knob for more than 5 seconds. The oil life indicator % will change to 100%. What is the Honda Maintenance Minder System?
Can you reset the oil Minder on a Honda?
Authorized Honda dealers will automatically reset your maintenance minder system as part of the service, but if you’ve changed the oil yourself or had the service performed elsewhere, you can manually reset the oil maintenance light with a few simple steps. Here are the instructions for resetting the oil maintenance light on a 2007 or newer Honda.