How do you reset the computer on a 2005 Honda Pilot?
From years: 2003, 2004, 2005.
- Turn off the engine.
- Hold the button for at least 10 seconds, until the indicator resets.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
How to fix Honda Pilot emissions warning light?
Re: Honda pilot emissions warning light. To resolve the issue, tighten the gas cap or replace it, and then disconnect the battery. Let it sit for 5 to 10 minutes and then reconnect it. If not solved, then there can be a variety of reasons why these lights illuminate i.e. the fuel injector may need to be replaced.
When to reset the Check Engine light on Honda Civic?
Continue reading to learn how to reset this light and save yourself the dealership cost. This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter.
Where is the Check Engine light on a Honda?
Turn the key into the “off” position if either of these occurs. Figure 1. A steady check engine light. (Related Article: Warning Lights – Honda-Tech.com) In the passenger’s side foot well, remove the kick panel by the side door. This will allow you access to the Engine Control Unit (ECU) and jumper plug (service connector).
How can I Fix my Honda Pilot engine?
Bring the Honda to a parts store to have them read stored engine codes to determine what’s going on (a free service at most stores). They will plug a hand held scan tool into a diagnostic port under the dash, and ‘read’ any codes in the cars computer.
Re: Honda pilot emissions warning light. To resolve the issue, tighten the gas cap or replace it, and then disconnect the battery. Let it sit for 5 to 10 minutes and then reconnect it. If not solved, then there can be a variety of reasons why these lights illuminate i.e. the fuel injector may need to be replaced.
How do you reset the warning light on a Honda?
Observe the instrument panel to make sure the warning light or lights have shut off. Press and hold the reset button, located under the odometer. Turn the ignition key to the “on” position while still depressing the reset button. Hold the button until the light turns off. Turn off the vehicle and wait 60 seconds.
What causes reset VSA light and indicator Honda Pilot?
Searched web for two days w/o success. Finally took it to dealer. They Quote “Scanned for DTC’s and found Code 84-1 Sensor Logic Failure due to possible battery disconnect and/or low voltage. Battery sensor not calibrated. Reset TCS light and calibrated system.” Unquote. Of course, I had to foot the bill for the diagnostics & labor.
Where is the reset button on a Honda?
Find the slot for the internal reset button on the driver’s-side part of the dashboard to the left of the “maintenance required” light. Put the ignition key into that slot to press the internal reset button and then remove. Put the key into the ignition and start the engine.