How do you reset the check engine light on a 2003 Toyota Camry?
press down the reset button, turn off the ignition while holding down the reset button turn the ignition key to the Accessory position ( the position before engine run) the digital mileage will turn to a set of dashes, keep the button depressed until all the dashes disappear then release the button you are holding …
How do I reset the check engine light on a 2002 Toyota Camry?
Put the key into the ignition and turn on the car but don’t turn over the engine. Wait a few minutes then put the fuse back in place. You should notice the check engine light blinking a few times on the instrument panel, then it will go off. Turn off the engine and replace the fuse panel cover.
How to reset the engine light on a Toyota Camry?
Remove the fuse puller from inside the fuse panel and use it to pull the fuse out for the electronic control unit. Put the key into the ignition and turn on the car but don’t turn over the engine. Wait a few minutes then put the fuse back in place.
Is there a way to reset the Check Engine light?
Regardless, here’s the quick and easy way to reset the CEL that is currently plaguing your dash. This article applies to the Toyota Camry (1997-2001). If you see the check engine light but your car is otherwise acting normally, chances are the check engine light is reporting something relatively minor.
How to turn off Check Engine light in Toyota?
You can solve this by connecting the scan tool to the onboard diagnostic connector. You can find this under your steering wheel. Then turn your ignition on and press the red button on your scan tool. Once done, you will be able to read a set of error codes. After which, you can press the erase button on your scan tool, and this will clear them.
Why is my Check Engine light not turning off?
If the Toyota check engine light doesn’t turn off, it is a problem that has not been fixed yet. Reread the codes and fix any present codes. Can I clear the codes without fixing the problem? Clearing Toyota fault codes without fixing the problem is not recommended.