How do you reset the belt light on a prairie 360?
Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were. Don’t foget to fasten them back up to the frame, if you pulled the strap off of them. Cut the key on to verify the procedure worked.
What to do when your belt light keeps coming on?
Belt light came on and bike went to limp mode. Checked the toggle switch in the cover and did the belt light reset procedure. Belt toggle switch was not tripped as it was still in on position. Still reset the light and switched the toggle switch back and forth a few times just to be on the safe side.
Where are the plugs on a Kawasaki Prairie 360?
Then, find the black and grey plugs up under the gas tank cover. These are on the clutch side, just above the belt snsor. Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were.
Cut the key on for about 5 seconds, or untill you see the flashing lights momentarily blink differently. Then cut the key back off. Plug the grey and black plugs up the way they were. Don’t foget to fasten them back up to the frame, if you pulled the strap off of them. Cut the key on to verify the procedure worked.
When to reset belt light on Kawasaki ATV?
However, the belt light may stay on after flipping the switch back to “ON”, or it may have come on automatically at 100 hours to get you to return the machine to the dealer for inspection even though the belt switch is not tripped. The following procedures will reset the light if the belt switch is not tripped.
Where is the belt light reset button on a Kawasaki P650?
Belt light reset procedure for late 2003 and later P650, P360, and BF650SRA. 1. Turn the ignition switch OFF. 2. Disconnect both sets of 5 pin connectors located above the CVT cover. Note: These connectors are located just beneath the shift handle on the right side of the 650; one is black and one is grey.
Can a 2002 650 CDI trip a belt?
The 2002 650 never needs this light reset procedure, the CDI will never trip the light by itself. If the belt switch is tripped, adjust the belt and flip the switch back to “ON” (a loose belt flips it to off). A flipped switch will cause a power loss.