How do you reset the airbag light on a Toyota RAV4?
How to Reset the Airbag Light on a Toyota
- Find the fuse panel cover under the steering column and open it with your fingers. Pull down on it from the top.
- Look for a yellow electrical connector.
- Take a paperclip and unfold it.
- Put the yellow electrical connector back in place and close the panel cover.
How do you reset the maintenance light on a 2017 rav4?
How To Turn Off Maintenance Light on Toyota RAV4
- Put your key in the ignition. Turn the key to position one.
- Push the trip meter reset button on the dashboard. Hold it down for a second or two.
- Continue to hold the odometer button for around ten seconds.
- Once off, release the odometer button.
Where is trip reset button on Toyota rav4?
Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out. Once off, release the odometer button and start the car.
How do I fix the SRS light on my Mercedes?
Unfortunately, the SRS Airbag light doesn’t reset on its own. Even if the problem has been addressed, you will need an Airbag scanner to reset the light. Very often the light goes on because of a dying battery. But once the light is on, it will stay on even when you install a new battery, until you manually reset it.
When do the indicator lights turn on on a Toyota RAV4?
indicator *1: These lights turn on when the engine switch is turned to the “on” position (vehicles without a smart key system) or ignition on mode (vehicles with a smart key system), to indicate that a system check is being performed. They will turn off after the engine is started, or after a few seconds.
When does the BSM turn off in a Toyota RAV4?
When the bsm main switch is set to on while the engine switch is in the “on” position (vehicles without a smart key system) or ignition on mode (vehicles with a smart key system). If the system is functioning correctly, the bsm outside rear view mirror indicators will turn off after a few seconds.
How do you reset the SRS light on a Honda CRV?
Put the key in the ignition and turn it on, but don’t start the engine. Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again. Repeat Step 3 and the SRS light will blink twice and turn off.
How do you turn off the SRS light?
Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again. Repeat Step 3 and the SRS light will blink twice and turn off. Unshort the two wires. This will cause the SRS light to blink twice.