How do you reset a LR3?

How do you reset a LR3?

How do you reset service light indicator Land Rover LR3.

1. Hold down the reset button on the dashboard to reset the LR3 trip counter.
2. Turn the ignition key to the II position on the ignition.
3. Continue holding the reset button for five seconds until a new menu appears on the digital display.

How do you reset the service light on a 2005 LR3?

How To Reset Land Rover LR3 Service Required Light in 3 Easy Steps!

1. Release the TRIP RESET button within 10 seconds of entering the reset mode, the information display will show “DIST” or “OIL”
2. Press the TRIP RESET button within 10 seconds of releasing it and hold for more than 5 seconds.

How do you reset the service indicator on a Land Rover Discovery 3?

Procedure to check/reset service status, distance counter on a Land Rover Discovery 3.

1. Switch ignition OFF.
2. Press and Hold left instrument panel reset button, switch ignition ON to position I (accessories).
3. Keep reset button pressed for approximately 5 seconds until the LCD displays RESET SIA.

How do you check the transmission fluid on a 2006 Land Rover?

Steps to Checking Your Transmission Fluid

1. Turn the car on.
2. Find the transmission fluid dipstick.
3. Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger.
4. Use a rag to wipe off the dipstick.
5. Use a funnel to bring the fluid level up to the right spot.

How do you turn off the service engine light on a Range Rover?

Reset Your Check Engine Light: Disconnect the Battery

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.

What does suspension fault mean on Land Rover?

If the fault becomes active when the suspension is at “normal” height, the suspension is locked, preventing it from raising or lowering with a warning message “Normal Height Only”. If the suspension is lowered when the fault becomes active, it fails to raise and the warning message to not exceed 35 MPH is shown.

How do you reset the service light on a lr4?

Here’s how to do it:

1. Open the bonnet and the driver’s door.
2. Place the ignition to the ON position without starting the engine.
3. Fully depress and hold the BRAKE and GAS pedals for 30 seconds.
4. Turn off the ignition and then start the engine to confirm the service light has been reset.

Why does my Land Rover LR3 not get out of Park?

Over the weekend my ’07 LR3 would not get out of Park. The messages on the dash were “Transmission Fault Limited” & “Special Program Off” & “Suspension Fault” and instead of a D for drive an F was showing on the gears as well as the engine light being on.

Is there a transmission fault in a 2006 Land Rover?

I have an 06 with 53K on it.. was buzzing down the New York State Thruway Yesterday doing only about 60 at the time and the Transmission Fault notice came on the dash. It beeped, then disappeared. This morning when I started her up, same thing. On, then off. I feel no difference in the way she drives.

When did transmission fault 2006 LR3 come on?

Discussion in ‘ LR3 ‘ started by mirepoixmatt, May 14, 2011 . I have an 06 with 53K on it.. was buzzing down the New York State Thruway Yesterday doing only about 60 at the time and the Transmission Fault notice came on the dash. It beeped, then disappeared. This morning when I started her up, same thing.

Why is the gear indicator not working on my Land Rover?

You might want to look at that, spray with some WD40, as a preventative measure, or replace the little inexpensive parts with it, and treat the new ones with anti-seize. This issue is usually associated with seemingly slipping in drive, and the gear indicator not working, or displaying incorrectly on the dash.