How do you replace a sliding door cable on a Honda Odyssey?
Attach the door at this point if you want. Back inside, roll the cables around the pulley as much as you can and push it into the housing. The gear the pulley sits on moves quite freely, so you will have a hard time lining it up right. Clip in the white stoppers, and push the springs into place.
How do you change the cable on a sliding door?
Back inside, roll the cables around the pulley as much as you can and push it into the housing. The gear the pulley sits on moves quite freely, so you will have a hard time lining it up right. Clip in the white stoppers, and push the springs into place. This is a pain. The straight piece coming off the springs feed into a hole on either side.
What kind of wire do you use for a sliding door?
Some Home Depot stores in the US stock 1/16” stainless steel wire rope. That would work too. Although one of the aircraft guys my father-in-law talked to said that the stainless stuff is weaker and also doesn’t like to be constantly bent.
How big should a sliding door cable be?
Thicknesses are in millimeters, so you need be no thicker than 1.5mm (1/16″ is 1.5875mm). The length of the cable is very important to get right. You don’t have much leeway. For the driver’s side, the cable going toward the front of the van is about 66”. The cable going around the back is about 62”.
Attach the door at this point if you want. Back inside, roll the cables around the pulley as much as you can and push it into the housing. The gear the pulley sits on moves quite freely, so you will have a hard time lining it up right. Clip in the white stoppers, and push the springs into place.
Back inside, roll the cables around the pulley as much as you can and push it into the housing. The gear the pulley sits on moves quite freely, so you will have a hard time lining it up right. Clip in the white stoppers, and push the springs into place. This is a pain. The straight piece coming off the springs feed into a hole on either side.
Some Home Depot stores in the US stock 1/16” stainless steel wire rope. That would work too. Although one of the aircraft guys my father-in-law talked to said that the stainless stuff is weaker and also doesn’t like to be constantly bent.
Thicknesses are in millimeters, so you need be no thicker than 1.5mm (1/16″ is 1.5875mm). The length of the cable is very important to get right. You don’t have much leeway. For the driver’s side, the cable going toward the front of the van is about 66”. The cable going around the back is about 62”.