How do you replace a front axle U-joint?
Use a collar to support the bottom that is open in the middle to allow the u-joint cap to be pressed down. Use a small collar on the top to drive the u-joint down, without contacting the yoke, on the topside. This pic shows the results of press operation described above. Remove the cap that is now exposed.
What’s the best way to remove an U-joint?
A vise is used to remove the u-joint by pressing the bearing cups out. A small socket is positioned over one bearing cap (use a socket just slightly smaller than the diameter of the bearing cap) and a larger socket is placed over the opposite bearing cap to receive the cap as it is pressed out of the yoke by tightening the vise.
Can a worn out U-joint be replaced?
With the driveshaft out, attempt to move each joint fully in each direction. They must move smoothly without binding in all directions. The bearing caps are a pressed-fit in the yoke and should not move. Any roughness, binding, or wear felt during this check indicates replacement is needed since u-joints are not repairable.
How do you remove you joint bearing cups?
Three common methods are used to remove the pressed-in, u-joint bearing cups from the driveshaft. One method requires a u-joint removal tool which is rather expensive unless you will be using it repeatedly as a professional technician. Another method requires using a big hammer and hitting things hard.
Zip Products also has a special tool available for removing and installing u-joints, shown here. It consists of a sliding cylindrical hammer (top), a receiver cup (lower left) and a button (lower right). The button goes into the lower bout of the sliding hammer and is retained by tightening the four Allen screws for removing u-joints.
What’s the best way to replace a universal joint?
Dislodge the universal joint from the both the yoke and the driveshaft. Remove all dirt and debris from the entire drive shaft assembly, assuring that it is completely clean. Apply a small amount of grease to the replacement caps.
How do you remove retaining clips from universal joints?
Remove the retaining clips with a pair of pliers. The U-joint is held in with a clip in each of the 4 openings on the yoke. Reach into these openings with a pair of pliers and pull the clips out. A needle nose plier will help you reach the clips better.
Where to put a new U-joint on a corvette?
Place a new u-joint with the bearing cups removed in the differential-side flange of the half shaft. Be careful when you remove the bearing cups, as they are lined with needle bearings which can fall out fairly easily.