How do you replace a distributor on a car?
Distributors are bolted to the engine block or the cylinder head. The replacement procedure is as follows: Once all diagnostic tests are complete and the distributor is confirmed to be faulty, disconnect the battery negative cable.
What should I do if my distributor is faulty?
The replacement procedure is as follows: Once all diagnostic tests are complete and the distributor is confirmed to be faulty, disconnect the battery negative cable. Set engine at top dead center on the compression stroke for cylinder no. 1.
What happens when you take the distributor out of the engine?
Do not crank the engine or move the car in gear while the distributor is out of the engine . If the engine is turned, the timing will have to be reset. Before removing the distributor cap, tag the lead to the cylinder used for timing and mark its position on the distributor body. Make sure that the battery is disconnected.
How do you replace a distributor on a Honda Civic?
Unbolt and remove the distributor. Temporarily cover the hole in the head or block so no foreign matter drops into the engine. Install new distributor and new cap and rotor, with the rotor pointing to the cylinder no. 1 firing-order electrode of the distributor cap. Reconnect all wiring and reconnect battery negative cable.
What should I do to replace my distributor?
Install new distributor and new cap and rotor, with the rotor pointing to the cylinder no. 1 firing-order electrode of the distributor cap. Reconnect all wiring and reconnect battery negative cable.
How does a distributor go into an engine?
In order for the distributor shaft to go into the engine completely, it needs to mesh with the oil pump gear. This may require manually cranking the engine slightly to jiggle the distributor shaft in. Install the new rotor to the distributor and check to see if it lines up with the number one spark plug wire on the old distributor cap.
Unbolt and remove the distributor. Temporarily cover the hole in the head or block so no foreign matter drops into the engine. Install new distributor and new cap and rotor, with the rotor pointing to the cylinder no. 1 firing-order electrode of the distributor cap. Reconnect all wiring and reconnect battery negative cable.
How do you replace a spark plug distributor?
When removing, take the old distributor cap off, but leave it connected to the spark plug wires. Note the location of the metal vacuum housing on the side of the distributor. Insert the new distributor into the engine, being sure to replace it so the vacuum housing is in the same position as the old distributor.