How do you replace a bad CV joint?
How to Replace a CV Axle
- There is a video at the bottom of this guide showing this job being done.
- Remove the Axle Nut Cotter Pin.
- Remove the Axle Nut.
- Disconnect Ball Joint.
- Remove the Outer CV Joint.
- Match the Old CV Axle to the New Unit.
- Install the New CV Axle.
- Reconnect the Lower Ball Joint.
How much does it cost to replace a CV joint?
CV Joint Replacement Cost. A CV joint itself can cost between $95 and $210. Hiring a mechanic to perform a replacement will be between $165 and $800. The price mainly depends on whether you’re replacing a double or single axle.
What should I do if I have a bad CV joint?
You will be going in a circle, so make sure the area around you is clear. As you move backward in a circle, the popping sounds should get louder if you have a bad CV joint. You’ll either have to replace the joint or the entire shaft assembly.
Can a torn boot cause a CV joint to leak?
If you have a torn boot in your vehicle, then it is going to be susceptible to leaking grease. This grease, of course, is the lubricant of the CV joint that allows it to run smoothly. This grease could potentially be thrown into the edges of the corresponding tire as the axle is in motion.
How do you remove a CV joint from a hard drive?
Remove the clamp securing the CV boot and then proceed to remove the CV joint from the drive shaft. You will need to nudge the joint off the shaft using a weighted tool. Be careful not to damage the shaft while removing the joint. You can also use a CV joint extraction tool if you have access to one.
How much does it cost to repair a CV joint?
Know what price you should pay to get your vehicle fixed. The average cost for a CV joint replacement is between $3,198 and $3,278. Labor costs are estimated between $305 and $385 while parts are priced at $2893.
How do you change CV joint?
How-to steps for replacing two CV joint axles Step 1: This is a rear drive vehicle with two CV joint axles. Step 2: In this case, suspension disassembly was not required. Step 3: Loosening but not removing the strut top mounts and sway bar end link bushings can provide a bit more suspension travel for easier axle removal.
What is a bad CV joint?
If the CV joint gets louder or quieter or noticeably changes in pitch while turning in either direction, then you have a bad outer joint. If the wheel angle doesn’t noticeably affect the CV joint sound, then it’s the inner joint.
Can I replace a CV joint myself?
If you really want to try replacing the CV joint boot or even the shaft yourself, you are going to need a variety of special tools. The lock-nut, or hub nut, will be screwed on extremely tight, so you will need either a breaker bar or a strong torque wrench and the correct size socket to loosen it up.