How do you remove the rear ignition switch?
Remove the tilt lever assembly screws. Pull back on the red tab of the rear ignition switch connector, and unplug it from the dash wire harness. Then pull back on the tab of the front switch connector, and unplug it to release the ignition switch from the lock cylinder.
How do you remove a tilt lever ignition switch?
The ignition switch is held in place by two Torx screws and mounted behind the tilt lever mechanism. Use a T25 Torx screwdriver to remove one screw underneath the tilt lever mechanism. Then, use the T20 screwdriver to remove one screw underneath the ignition switch. Figure 6. Remove the tilt lever assembly screws.
Where is the ignition switch on a Dodge Ram?
The ignition switch is held in place by two Torx screws and mounted behind the tilt lever mechanism. Use a T25 Torx screwdriver to remove one screw underneath the tilt lever mechanism. Then, use the T20 screwdriver to remove one screw underneath the ignition switch.
What should I do if my ignition switch is not working?
Keep pressing it in until you hear the click of the release pin setting into place inside the steering column. If you don’t hear a click from the release pin, the ignition switch isn’t properly seated yet. You may need to push in on the switch a little to make it click into place. Helpful? Reconnect the battery and test the new switch.
How do you replace an ignition switch on a car?
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
How do you replace the ignition switch on a 2002 Ford Explorer?
Remove the plastic knee bolster panel by detaching the two Phillips screws at the bottom of the panel. This is the plastic panel under the steering column. Carefully pry the top of the panel loose at a point directly above the lower-left screw, using a flat-head screwdriver.
How do you replace ignition switch on Honda Accord?
Route the wiring in the same manner the old switch wiring was routed, insert the switch into the steering column, and put back the ignition switch cover and screws. Use the electrical tape to corral any of the loose wiring. Put all paneling back the way it was by following the above directions in reverse.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.