How do you remove the lock cylinder on a Honda Civic?
Turn the ignition key to the first “I” position, this allows the pin to be depressed. At the same time, pull outward on the key and the cylinder will come out.
How to replace door lock cylinder 03-05 Honda Civic?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: SXu-7t9DOqlKcUY1)
How do you remove the ignition lock cylinder?
With the key still inserted, gently remove the ignition lock cylinder from the lock body. Step 8: Loosen the two screws on top of the lock body. You should see two screws that are located on the top of the lock body after you’ve removed the ignition lock cylinder. Loosen these screws about four full turns.
What to do if your Honda Civic key wont turn?
The easiest and most economical option is to simply replace the lock cylinder. This is the same assemble for the Honda Accord, Element, Civic, CrossTour, Fit, Insight, and Odyssey. Here is the link for the lock cylinder and 2 replacement keys to go with it: And if you just need a new set of key blanks, these are the ones you need:
Can you remove a key cylinder from a Honda?
Honda takes a lot of anti-theft precautions with its vehicles, and these precautions can make do-it-yourself car repair–such as removing the vehicle’s ignition switch and key lock cylinder–challenging. You have to deal with security issues and shut off power so you can work and with the actual hardware removal.
Do you need a new Honda Civic ignition lock cylinder?
As much as you drive your Honda Civic around town, the moment you lose your keys is the moment you need to order a new Honda Civic ignition lock cylinder from AutoZone. Once it arrives, install it and use the new key to regain the ability to access and drive your vehicle.
Honda takes a lot of anti-theft precautions with its vehicles, and these precautions can make do-it-yourself car repair–such as removing the vehicle’s ignition switch and key lock cylinder–challenging. You have to deal with security issues and shut off power so you can work and with the actual hardware removal.
How do you replace a broken trunk lock cylinder?
There is a possibility that the new cylinder will be missing the plastic clip that retains the rod in its proper location on the cylinder. If this is the case, use needle nose pliers to gently remove the old clip from the broken lock cylinder and install this clip onto the new cylinder.
What do I need to remove ignition cylinder?
There are three electrical connectors you must unplug to remove the key lock cylinder. The ignition switch’s connector should already be unplugged if you removed the switch; you also must disconnect the connectors to the immobilizer control unit and the lock cylinder/key light, which are both near the switch and cylinder.