How do you remove the center console from a jeep?
Hold the base of the shifter with one hand and pull it straight up and off with the other. Unscrew the four metal screws on the bottom sides of the center console. You may have to forward and recline your seat to its far ends to access these screws.
How to disassemble a Jeep Grand Cherokee dashboard?
Remove the final retainer bolt positioned on top of the brake pedal in a similar fashion.Slide the dash towards you and disconnect the electrical connectors going into the back side of the dash. Drag the dash up and carry it out of your Jeep. “Jeep Grand Cherokee 1993 thru 2004: All Models; Haynes Repair Manual”; John Haynes; 2004
How do you remove kick panels from Jeep?
Remove the retainer screws for the kick panels and pull the kick panels straight out. Pry off the trim pieces going around the glove box using the flathead screwdriver to reveal the retainer bolts. Remove these bolts with the socket wrench. Locate the retainer bolts on the ends of the dash panel and remove them with the socket wrench.
How do you remove radio from Jeep Cherokee?
Identify the two retainer screws for the radio panel. There is one screw on each side of the radio. Remove these screws with the Phillip’s head screwdriver and slide the panel forward. Unplug the radio’s electrical connectors. Drag the heater control assembly forward.
How do you disassemble a jeep dashboard?
Pry the trim pieces of the dashboard off with the flathead screwdriver then remove the vents in the same manner. Unbolt the top portion of the dash with the socket wrench.
Hold the base of the shifter with one hand and pull it straight up and off with the other. Unscrew the four metal screws on the bottom sides of the center console. You may have to forward and recline your seat to its far ends to access these screws.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
What happens if I Reset my Jeep ECM?
To finish off this post , here are a couple of things you should keep in mind. Resetting your Jeep ECM will not have any effect on your vehicle’s mileage, Resetting it should not cause any issues between your other module so feel free to this as many time as you want if you’re trying to diagnose a problem with your car. For good measure.
How do you remove a negative battery from a Jeep Cherokee?
Pop the hood on your Jeep and loosen the negative battery cable. Pull the negative battery cable off the negative post and set it to the side.
How do you remove a vent from a center console?
Remove the side trim. The side trim is held by many fragile clips, so be careful as you pry it loose. You’ll need to pry out the vent on the back of the center console. With the side trim removed, you can also push it out from the other side. Disconnect the electrical connector for the vent after you remove it, then set the vent aside.
How do you remove MMI from center console?
Pull up the clips in the center to remove the MMI control panel trim. You’ll need to reverse the previous steps as summarized here. Return MMI control panel to the center console. Press MMI control panel trim to the control panel until clips snap into position. Tighten four bolts on the back of the center console.
Can a center console be removed from a SLK?
Center consoles are a common headache in R170 SLKs. The factory paint doesn’t stick well to the console’s flexible ABS plastic. Many SLK owners get tired of the splotchy appearance and eventually remove the console to replace or repaint it. Console/interior painting is its own story.