How do you remove ignition switch from Suzuki GS?
Then grab a very small flat-head screwdriver and push the big half-moon looking pin inside the cylinder towards the shaft. This is the pin that holds plug inside the cylinder. It is the very last pin on the plug and is the biggest one. Once that is out of the way, start pushing the shaft out of the cylinder with your finger or a socket extension.
Why is my Suzuki King Quad 300 not working?
Hi and welcome to JustAnswer,Almost always, your described problem would indicate that power from the battery is not reaching the electrical system of the Suzuki King Quad 300. Possible faults are:
What to do if your Suzuki ignition cylinder stops turning?
This tutorial is for Suzuki GS850 GZ ignition cylinder, but it is the same in principal for many other makes and models of motorcycles. If your ignition key stops turning, which often happens when the steering is locked positionin , first shoot a stream of WD-40 down the hole to see if it starts turning again.
What is the service manual for a Suzuki quad?
The Suzuki service manual downloads for the above listed models describes the service procedures for the complete vehicle. Follow the Maintenance Schedule recommendations to ensure that the all-terrain vehicle (ATV) (Quad) is in peak operating condition and the emission levels are within the standards set by the your states/county Resources Board.
Hi and welcome to JustAnswer,Almost always, your described problem would indicate that power from the battery is not reaching the electrical system of the Suzuki King Quad 300. Possible faults are:
Is there a neutral switch on a quad 300?
there is a neutral switch. Follow the blue wire from the reverse switch; rather than disconnect the neutral switch, bypass it. Jumper / short the blue wire to ground. The neutral light should lit up; if not, jumper / short the blue / black wire to ground; verify that it is not engaged in reverse.
Is there an overheat switch on a quad 300?
In response to your queries: there is no overheat switch, but there is an oil temp switch; there is a neutral switch. Follow the blue wire from the reverse switch; rather than disconnect the neutral switch, bypass it. Jumper / short the blue wire to ground. The neutral light should lit up; if not, jumper / short the blue / black wire to ground;
What should I do if my quad 300 shuts down?
Follow the blue wire from the reverse switch; rather than disconnect the neutral switch, bypass it. Jumper / short the blue wire to ground. The neutral light should lit up; if not, jumper / short the blue / black wire to ground; verify that it is not engaged in reverse.
Then grab a very small flat-head screwdriver and push the big half-moon looking pin inside the cylinder towards the shaft. This is the pin that holds plug inside the cylinder. It is the very last pin on the plug and is the biggest one. Once that is out of the way, start pushing the shaft out of the cylinder with your finger or a socket extension.
How does a Suzuki ignition cylinder lock work?
The wafers sit on tiny springs and when you insert your key in, the notches in the key will position these wafers in an order that allows the plug to turn freely inside the cylinder, hence unlocking and starting the bike. With the key in the lock,the outside edge of all wafers should be flush with the surface of the plug.
What should I do if my ignition switch is not working?
A dirty but quick fix is to insert your newest key inside the lock, and then file away the outside of the wafers that stick out of the plug. Motorcycle ignitionlocks are not that great to begin with , so whether you file or not, always chain your bike to something when parked. I always do.
What was the ignition switch on a 1976 Alouette snowmobile?
You are bidding on a NOS Rupp ignition switch assembly with keys for the 1976-78 Rupp Magnum and Nitro model snowmobiles. This was also used on the 1976 Alouette Super Brute and Brute model snowmobiles Hope someone can put it to use. Buyer pays shipping charges of $8.00.