How do you remove an inner lock?

How do you remove an inner lock?

1. Step 1: Locate & Unscrew the Set Screw. This screw will be on the shank of the inside knob (the one you use to lock the door).
2. Step 2: Unscrew the Door Handles.
3. Step 3: Remove the Rose Plates.
4. Step 4: Remove the Face Plate.
5. Step 5: Remove the Mortise Lock.

Can I use wd40 on my door lock?

This is what we find works best to keep your lock in its best working condition lubricate the lock cylinder. Do not use WD-40, WD-40 is a solvent, not a lubricant and will, in fact, remove any type of lubricant that is in the cylinder. Use a lubricant that has a silicone, graphite or Teflon base only.

How to remove and refit the drivers door lock assembly?

Drivers side was a sod…I only undid the bottom of the channel through which the electric window cable runs; this gives plenty of room through which to retrieve the door lock mechanism.

Is the driver’s side door lock not working?

You can do a forum search and try to find the post. Undoubtedly, the JL went to the dealer. Not sure if the forum member came back and commented on end result. Recently, there was a new forum member reporting the same issue but with the driver’s side door I believe. You can do a forum search and try to find the post.

What to do if your door lock actuator is not working?

Sitting in the car with the doors shut, press on the locking switch of the affected door lock actuator. Then operate the inside door handle and open the door. If the door lock actuator is operating correctly, opening the interior door handle will override the door lock actuator.

Do you need to remove the cluster from a door lock?

Lift the whole panel straight up to clear it of the catch behind the door handle. Note: If your vehicle has electronic door locks, you will need to remove the door lock cluster panel from the door panel. Before removing the door panel, remove the screws attaching the cluster to the panel.