How do you remove a water pump from a Toyota Camry?
Remove the water pump pulley by wedging a pry bar behind the pulley and removing the four 12mm bolts. Remove the four 10mm bolts and two nuts that hold the water pump fastener in place. Spray down the area with brake cleaner. Place a drain pan underneath and remove the water pump with a pry bar.
When to replace timing belt and water pump on Toyota Camry?
Save yourself a bundle by doing some general maintenance on your Camry’s engine yourself. This article applies to the Toyota Camry (1997-2011). Many Camry owners dread the 60,000 mile marker because of the costly timing belt and water pump recommended maintenance interval.
Where is the drain plug on a Toyota Camry?
Remove the drain plug from the bottom of the radiator on the passenger side. Replace the plug when finished. You will also want to drain it from the engine block as well by removing the two drain plugs on the bottom front and rear of the engine. The rear is a little more difficult to get to.
How do you replace the radiator in a Toyota Camry?
Remove the five lugs and pull the tire. Remove the drain plug from the bottom of the radiator on the passenger side. Replace the plug when finished. You will also want to drain it from the engine block as well by removing the two drain plugs on the bottom front and rear of the engine. The rear is a little more difficult to get to.
How to remove water pump from V6 engine?
Disconnect the bolt connecting the water inlet pipe to the alternator adjuster on a V6 engine, then remove the inlet pipe and thermostat. Remove the Number 3 timing belt cover by releasing the wiring harness clips and pulling the harness back. Remove the bolts for the water pump and remove the pump.
What do you need to replace a water pump?
Install the replacement water pump with a new gasket, sealer and O-rings. Tighten the bolts to 78 inch-pounds on a four cylinder engine and 69 foot-pounds on a V6; tighten them in several even steps. Reinstall the timing belt and all the other engine parts in the reverse order of removal.
What is the OTC water pump pulley remover?
Video Player is loading. This is a modal window. OTC’s 7483A Water Pump Puller Remover/Installer helps remove and install water pump pulleys faster and easier on specific Ford, Lincoln and Mercury 3.0L DOHC V6 engines.
How long does it take to remove water pump pulley?
I have a 2008 Mercury Milan and this tool came with everything to take off and put on the the water pump pulley (the pulley above the pump and turned by the cam). Took just over two hours to do the whole job and taking the pulley off and putting it back on was one of the easiest tasks to do with this tool.
What kind of car does the water pump puller remover fit?
Fits: Ford Escape 2001–2012, Ford Fusion 2006–2012, Ford Taurus 2001–2005, Lincoln MKZ 2007–2012, Mercury Mariner/Milan 2006–2011, Mercury Sable 2001–2005. Rugged, all metal construction ensures this versatile tool set will deliver reliable long-term service.