How do you remove a torque tube drive shaft?
Inside all the gunk inside the front end of the torque tube, there’s a snap ring that holds the speedometer gear in place. Dig that out and remove and then, you’ll be able to slide off the torque tube.
How do you remove a stripped head bolt?
Options For Removing a Stripped Bolt Head
- Locking Pliers. Any locking pliers like Vise-Grips are a great option that everybody should have in their garages.
- Heat Therapy. Using a blowtorch—finally, fire!
- Cut a Slit. Using a Dremel tool or some other type of cutter or grinder, cut a slit into the head of the bolt.
How does a torque tube work?
The torque tube solves that problem by coupling the differential housing to the transmission housing and therefore propels the car forward by pushing up on the engine/transmission and then through the engine mounts to the car frame, with the reverse happening during braking.
What tool is used to remove stripped bolts?
A rotary tool can be used to cut a notch into the head of the bolt. With the notch cut you can then use a flat head screwdriver to remove the bolt. Use a small cutting wheel with your high-speed rotary tool for this project. With safety glasses on, carefully cut across the head of the bolt.
How long do Tacoma joints last?
How often do universal joints need to be replaced? Universal joints can have a lengthy service life if properly maintained, and 100,000 miles is not at all unreasonable to expect.
What kind of bolts do you need to remove a driveshaft?
Remove Driveshaft Bolts Remove the shaft differential flange mounting bolts. These bolts will be very tight so use good quality tools to avoid stripping. Some bolts can head 12 point heads as in this example which used a 13mm 12 point socket to remove.
Can a 12 point head be removed from a driveshaft?
These bolts will be very tight so use good quality tools to avoid stripping. Some bolts can head 12 point heads as in this example which used a 13mm 12 point socket to remove. These bolts also use lock tight to avoid coming loose while in operation and can be reapplied when reinstalling. 3. Remove Driveshaft Flange
What happens when a driveshaft is removed from a car?
Something you should know that may not be thought of is when a driveshaft is removed the car will no longer be in park. The car will roll because the link between the drive wheels and transmission is removed. You will need to raise the car or truck up using a floor jack and jackstays. Wear protective eyewear and gloves before you begin. 1.
What are the universal joints on a driveshaft?
A driveshaft can be one or two pieces with a center support bearing in the middle. There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump.